© The Institution of Engineering and Technology
A low-cost, highly reflective, liquid organic nanostructure silver conductor with superior conductivity, using back contact reflectors in amorphous silicon (a-Si) single-junction superstrate configuration thin-film solar cells produced using a non-vacuum screen printing process is proposed. The conductive paste is composed of Ag nanowires (Ag NWs) mixed with an Ag nanostructure (Ag NS) sheet. The paste is referred to as ‘Ag NWS’. A comparison of silver conductor samples with vacuum-system-sputtered silver samples indicated that the short-circuit current density (J sc) and the open-circuit voltage (V oc) of Ag NWS conductor cells exceeded 0.22 mA/cm2 and 66 mV, respectively. The Ag NWS conductor with back contact reflectors in solar cells was analysed using external quantum efficiency measurements to effectively enhance light-trapping ability in a long wavelength region (580–700 nm). The cells constructed using the optimised Ag NWS demonstrated an increase of approximately 6.1% in power conversion efficiency under AM 1.5 illumination. These results indicated that the Ag NWS conductor back contact reflector layer is a suitable candidate for high-performance a-Si thin-film solar cells.
References
-
-
1)
-
13. Liu, J.C., Lin, C.C., Chen, Y.H., et al: ‘Enhancing light-trapping properties of amorphous Si thin-film solar cells containing high-reflective silver conductors fabricated using a nonvacuum process’, Int. J. Photoenergy, 2014, 2014, pp. 627127-1–627127-5.
-
2)
-
10. Cho, J.S., Baek, S., Lee, J.C.: ‘Surface texturing of sputtered ZnO:Al/Ag back reflectors for flexible silicon thin-film solar cells’, Sol. Energy Mater. Sol. Cells, 2011, 95, pp. 1852–1858 (doi: 10.1016/j.solmat.2011.02.007).
-
3)
-
2. Ramanujam, J., Verma, A.: ‘Photovoltaic properties of a-Si:H films grown by plasma enhanced chemical vapor deposition: a review’, Mater. Express, 2012, 2, pp. 177–196 (doi: 10.1166/mex.2012.1073).
-
4)
-
8. de Jong, M.M., Sonneveld, P., Baggerman, J.J., et al: ‘Utilization of geometric light trapping in thin film silicon solar cells: simulations and experiments’, Prog. Photovolt., 2014, 22, pp. 540–547 (doi: 10.1002/pip.2299).
-
5)
-
19. Chen, Y.R., Li, Z.Q., Chen, X.H., et al: ‘Improved performance of flexible amorphous silicon solar cells with silver nanowires’, J. Appl. Phys., 2012, 112, pp. 124320-1–124320-6.
-
6)
-
1. Konagai, M.: ‘Present status and future prospects of silicon thin-film solar cells’, Jpn. J. Appl. Phys., 2011, 3, pp. 030001-1–030001-12.
-
7)
-
3. Jelle, B.P., Breivik, C., Røkenes, H.D.: ‘Building integrated photovoltaic products: a state-of-the-art review and future research opportunities’, Sol. Energy Mater. Sol. Cells, 2012, 100, pp. 69–96 (doi: 10.1016/j.solmat.2011.12.016).
-
8)
-
15. Ellmer, K., Klein, A., Rech, B.: ‘Transparent conductive zinc oxide: basics and applications in thin film solar cells’ (Springer Berlin Heidelberg, Berlin, 2008).
-
9)
-
7. Lee, J.M., Yun, S.J., Kim, J.K., Lim, J.W.: ‘Texturing of Ga-doped ZnO transparent electrode for a-Si:H thin film solar cells’, Electrochem. Solid-State Lett., 2011, 14, pp. B124–B126 (doi: 10.1149/2.018111esl).
-
10)
-
11. Cho, J.S., Baek, S., Park, S.H., et al: ‘Effect of nanotextured back reflectors on light trapping in flexible silicon thin-film solar cells’, Sol. Energy Mater. Sol. Cells, 2012, 102, pp. 50–57 (doi: 10.1016/j.solmat.2012.03.031).
-
11)
-
4. Shah, A.V.: ‘Thin-film silicon solar cells’ (EPFL Press, Lausanne, 2010).
-
12)
-
17. Hsiao, J.C., Chen, C.H., Yang, H.J., et al: ‘Highly textured ZnO:B films grown by low pressure chemical vapor deposition for efficiency enhancement of heterojunction silicon-based solar cells’, J. Taiwan Inst. Chem. E., 2013, 44, pp. 758–761 (doi: 10.1016/j.jtice.2013.01.027).
-
13)
-
18. Springer, J., Poruba, A., Müllerova, L., et al: ‘Absorption loss at nanorough silver back reflector of thin-film silicon solar cells’, J. Appl. Phys., 2004, 95, pp. 1427–1429 (doi: 10.1063/1.1633652).
-
14)
-
16. Faÿ, S., Steinhauser, J., Nicolay, S., Ballif, C.: ‘Polycrystalline ZnO: B grown by LPCVD as TCO for thin film silicon solar cells’, Thin Solid Films, 2010, 518, pp. 2961–2966 (doi: 10.1016/j.tsf.2009.09.189).
-
15)
-
20. Springer, J., Rech, B., Reetz, W., et al: ‘Light trapping and optical losses in microcrystalline silicon pin solar cells deposited on surface-textured glass/ZnO substrates’, Sol. Energy Mater. Sol. Cells, 2005, 85, pp. 1–11.
-
16)
-
5. Theuring, M., Vehse, M., Maydell, K., Agert, C.: ‘AZO-Ag-AZO transparent electrode for amorphous silicon solar cells’, Thin Solid Films, 2014, 558, pp. 294–297 (doi: 10.1016/j.tsf.2014.02.042).
-
17)
-
21. Sze, M., Ng, K.K.: ‘Physics of semiconductor devices’ (John Wiley & Sons, Inc., Hoboken, New Jersey, 2007).
-
18)
-
9. Kim, H.S., Lim, J.W., Yun, S.J., et al: ‘Nano-scale texturing of borosilicate glasses using CF4-based plasma discharge for application in thin film solar cells’, j. Nanosci. Nanotechnol., 2012, 12, pp. 3464–3468 (doi: 10.1166/jnn.2012.5565).
-
19)
-
6. Islam, K., Alnuaimi, A., Battal, E., et al: ‘Effect of gold nanoparticles size on light scattering for thin film amorphous-silicon solar cells’, Sol. Energy, 2014, 103, pp. 263–268 (doi: 10.1016/j.solener.2014.02.023).
-
20)
-
12. Schropp, R.E.I., Zeman, M.: ‘Amorphous and microcystalline silicon solar cells: modeling, materials and device technology’ (Kluwer Academic Publishers, Boston, MA, 1998).
-
21)
-
14. Chen, Y.H., Fang, H.Y., Yeh, C.M.: ‘Raman scattering and electrical characterizations studies of hydrogenated amorphous silicon–germanium alloys prepared by 40 MHz plasma-enhanced CVD’, J. Non-Cryst. Solids, 2011, 357, pp. 1–3 (doi: 10.1016/j.jnoncrysol.2010.09.060).
http://iet.metastore.ingenta.com/content/journals/10.1049/mnl.2014.0416
Related content
content/journals/10.1049/mnl.2014.0416
pub_keyword,iet_inspecKeyword,pub_concept
6
6