© The Institution of Engineering and Technology
New scanning probes suitable for microwave impedance microscopy (MIM) measurements on any scanning platform using a piezoactuator are presented. The authors microfabricated piezoresistive cantilevers integrated with low-impedance, electrically shielded transmission lines to enable simultaneous topographical and electrical scanning probe microscopy. The probes provide topography feedback with nanometre vertical resolution for samples or setups where laser detection is not feasible or desirable. MIM is a scanning probe technique that uses the interaction of a gigahertz electrical signal with a sample, and yields a conductivity map of the sample at the nanoscale. The proposed design exhibits vertical displacement resolution of 3.5 nm in a measurement bandwidth from 1 to 10 kHz. The capacitance between shield and inner conductors measured with an impedance analyser is 9.5 pF and the trace resistance is 32 Ω. Sample location and topographic scanning capabilities using the self-sensing piezoresistor are demonstrated.
References
-
-
1)
-
Y. Kanda
.
A graphical representation of the piezoresistance coefficients in silicon.
IEEE Trans. Electron. Devices
,
1 ,
64 -
70
-
2)
-
B.D. Almquist ,
N. Melosh
.
Fusion of biomimetic stealth probes into lipid bilayer cores.
Proc. Natl. Acad Sci.
,
13 ,
5815 -
5820
-
3)
-
K. Lai ,
W. Kundhikanjana ,
M. Kelly ,
Z. Shen
.
Modeling and characterization of a cantilever-based near-field scanning microwave impedance microscope.
Rev. Sci. Instrum.
-
4)
-
L. Gross ,
F. Mohn ,
N. Moll ,
P. Liljeroth ,
G. Meyer
.
The chemical structure of a molecule resolved by atomic force microscopy.
Science
,
5944 ,
1110 -
1114
-
5)
-
S.-J. Park ,
J.C. Doll ,
A.J. Rastegar ,
B.L. Pruitt
.
Piezoresistive cantilever performance, part II: optimization.
J. Microelectromech. Syst.
,
1 ,
149 -
161
-
6)
-
C. Peng ,
J. Lin ,
C.T. Lin ,
K.N. Chiang
.
Performance and package effect of a novel piezoresistive pressure sensor fabricated by front-side etching technology.
Sens. Actuators A, Phys.
,
28 -
37
-
7)
-
J. Harley ,
T. Kenny
.
1/f noise considerations for the design and process optimization of piezoresistive cantilevers.
J. Microelectromechan. Syst. (JMEMS)
,
2 ,
226 -
235
-
8)
-
T.S. Ravi ,
R.B. Marcus ,
D. Liu
.
Oxidation sharpening of silicon tips.
J. Vac. Sci. Technol. B, Microelectron. Nanometer Struct.
,
6 ,
2733 -
2737
-
9)
-
G. Binnig ,
C.F. Quate ,
C. Gerber
.
Atomic force microscope.
Phys. Rev. Lett.
,
9 ,
930 -
933
-
10)
-
N. Harjee ,
A. Haemmerli ,
D. Goldhaber-Gordon ,
B.L. Pruitt
.
Coaxial tip piezoresistive scanning probes with sub-nanometer vertical displacement resolution.
Proc. IEEE Sens.
,
1962 -
1966
-
11)
-
S. Kal ,
S. Das ,
D.K. Maurya ,
K. Biswas ,
A. Ravi Sankar ,
S.K. Lahiri
.
CMOS compatible bulk micromachined silicon piezoresistive accelerometer with low off-axis sensitivity.
Microelectron. J.
,
22 -
30
-
12)
-
K. Lai ,
W. Kundhikanjana ,
M. Kelly ,
Z. Shen
.
Calibration of shielded microwave probes using bulk dielectrics.
Appl. Phys. Lett.
-
13)
-
K. Petersen
.
Silicon as a mechanical material.
Proc. IEEE
,
5 ,
420 -
457
-
14)
-
J. Berezovsky ,
R. Westervelt
.
Imaging coherent transport in graphene (part II): probing weak localization.
Nanotechnology
-
15)
-
Yang, Y.L., Lai, K.J., Tang, Q.C.: `A shielded cantilever-tip microwave probe for micro/nano surface imaging of conductive properties', 2011 IEEE 24th Int. Conf. on Micro Electro Mechanical Systems (MEMS), 2011, p. 79–82.
-
16)
-
Doll, J., Park, S., Harjee, N., Rastegar, A.: `Piezoresistive cantilever optimization and applications', Proc. Materials Research Society Symp., 2010, 1222.
http://iet.metastore.ingenta.com/content/journals/10.1049/mnl.2011.0679
Related content
content/journals/10.1049/mnl.2011.0679
pub_keyword,iet_inspecKeyword,pub_concept
6
6