Increasing discharge of sewage sludge is a threat to the ecological environment, and sludge treatment via combustion is the most feasible alternative. However, the low calorific value and high-water content of raw sludge results in poor firing performance and increases the risk of environmental pollution. Recently, co-combustion has emerged as a more environment-friendly technology. Herein, the combustion behaviours of sewage sludge, corn stalk and their mixture at four heating rates were studied via thermogravimetric experiments. Results yielded the division of weight loss into three stages for corn stalk: dehydration, combustion of volatiles and combustion of fixed carbon; four stages were identified for sewage sludge and the mixture of sludge and stalk: dehydration, combustion of volatiles, combustion of fixed carbon and thermal decomposition of a small amount of minerals. Synergistic analyses found that with a 60% blending ratio of sewage sludge, interaction between the components in the high-temperature range was greatly promoted. Gas emission characteristics showed that CO₂ was the main product during (co-)combustion, while the NO _x emissions at low (or high) temperatures for the blend were higher (or lower) than the theoretical values. Temperature had little effect on H₂S emissions, though it significantly affected SO₂ emissions during co-combustion.

References

1. 1)
  - 36. Wang, T., Hou, H., Ye, Y., et al: ‘Combustion behavior of refuse-derived fuel produced from sewage sludge and rice husk/wood sawdust using thermogravimetric and mass spectrometric analyses’, J. Clean. Prod., 2019, 222, pp. 1–11.
2. 2)
  - 20. Magdziarz, A., Wilk, M.: ‘Thermal characteristics of the combustion process of biomass and sewage sludge’, J. Therm. Anal. Calorim., 2013, 114, pp. 519–529.
3. 3)
  - 28. Buyukada, M.: ‘Uncertainty estimation by Bayesian approach in thermochemical conversion of walnut hull and lignite coal blends’, Bioresour. Technol., 2017, 232, pp. 87–92.
4. 4)
  - 14. Zhang, Z., Zeng, Q.: ‘Numerical simulation and experimental analysis on nitrogen and sulfur oxides emissions during the co-combustion of Longyan anthracite and sawmill sludge’, Fuel, 2019, 254, p. 115611.
5. 5)
  - 1. Holkar, C.R., Jadhav, A.J., Pinjari, D.V., et al: ‘A critical review on textile wastewater treatments: possible approaches’, J. Environ. Manage., 2016, 182, pp. 351–366.
6. 6)
  - 38. Chen, J., He, Y., Liu, J., et al: ‘The mixture of sewage sludge and biomass waste as solid biofuels: process characteristic and environmental implication’, Renew. Energy, 2019, 139, pp. 707–717.
7. 7)
  - 23. Ozawa, T.: ‘Kinetic analysis of derivative curves in thermal analysis’, J. Therm. Anal., 1970, 2, pp. 301–324.
8. 8)
  - 12. Xie, C., Liu, J., Zhang, X., et al: ‘Co-combustion thermal conversion characteristics of textile dyeing sludge and pomelo peel using TGA and artificial neural networks’, Appl. Energy, 2018, 212, pp. 786–795.
9. 9)
  - 37. Li, L., Ren, Q., Wang, X., et al: ‘TG–MS analysis of thermal behavior and gaseous emissions during co-combustion of straw with municipal sewage sludge’, J. Therm. Anal. Calorim., 2014, 118, pp. 449–460.
10. 10)
  - 16. Bhuiyan, A.A., Blicblau, A.S., Islam, A.K.M.S., et al: ‘A review on thermo-chemical characteristics of coal/biomass co-firing in industrial furnace’, J. Energy Inst., 2018, 91, pp. 1–18.
11. 11)
  - 13. Huang, J., Liu, J., Kuo, J., et al: ‘Kinetics, thermodynamics, gas evolution and empirical optimization of (co-) combustion performances of spent mushroom substrate and textile dyeing sludge’, Bioresour. Technol., 2019, 280, pp. 313–324.
12. 12)
  - 40. Wei, Y., Chen, M., Li, Q., et al: ‘Isothermal combustion characteristics of anthracite and spent coffee grounds briquettes’, J. Therm. Anal. Calorim., 2019, 136, pp. 1447–1456.
13. 13)
  - 4. Cieślik, B.M., Namieśnik, J., Konieczka, P.: ‘Review of sewage sludge management: standards, regulations and analytical methods’, J. Clean. Prod., 2015, 90, pp. 1–15.
14. 14)
  - 21. Maia, A.A.D., Morais, L.C.d.: ‘Kinetic parameters of red pepper waste as biomass to solid biofuel’, Bioresour. Technol., 2016, 204, pp. 157–163.
15. 15)
  - 17. Yanik, J., Duman, G., Karlström, O., et al: ‘NO and SO2 emissions from combustion of raw and torrefied biomasses and their blends with lignite’, J. Environ. Manage., 2018, 227, pp. 155–161.
16. 16)
  - 5. Niu, Y., Tan, H., Hui, S.: ‘Ash-related issues during biomass combustion: alkali-induced slagging, silicate melt-induced slagging (ash fusion), agglomeration, corrosion, ash utilization, and related countermeasures’, Prog. Energy Combust., 2016, 52, pp. 1–61.
17. 17)
  - 6. Liu, J., Jiang, X., Zhou, L., et al: ‘Co-firing of oil sludge with coal-water slurry in an industrial internal circulating fluidized bed boiler’, J. Hazard. Mater., 2009, 167, pp. 817–823.
18. 18)
  - 11. Wang, X., Deng, S., Tan, H., et al: ‘Synergetic effect of sewage sludge and biomass co-pyrolysis: A combined study in thermogravimetric analyzer and a fixed bed reactor’, Energy Convers. Manage., 2016, 118, pp. 399–405.
19. 19)
  - 34. Lin, J., Su, B., Sun, M., et al: ‘Biosynthesized iron oxide nanoparticles used for optimized removal of cadmium with response surface methodology’, Sci. Total. Environ., 2018, 627, pp. 314–321.
20. 20)
  - 30. Chen, J., Mu, L., Cai, J., et al: ‘Thermal characteristics and kinetics of refining and chemicals wastewater, lignite and their blends during combustion’, Energy Convers. Manage., 2015, 100, pp. 201–211.
21. 21)
  - 22. Cai, H., Zou, H., Liu, J., et al: ‘Thermal degradations and processes of waste tea and tea leaves via TG-FTIR: combustion performances, kinetics, thermodynamics, products and optimization’, Bioresour. Technol., 2018, 268, pp. 715–725.
22. 22)
  - 19. Huang, L., Liu, J., He, Y., et al: ‘Thermodynamics and kinetics parameters of co-combustion between sewage sludge and water hyacinth in CO2/O2 atmosphere as biomass to solid biofuel’, Bioresour. Technol., 2016, 218, pp. 631–642.
23. 23)
  - 3. Peng, X., Ma, X., Xu, Z.: ‘Thermogravimetric analysis of co-combustion between microalgae and textile dyeing sludge’, Bioresour. Technol., 2015, 180, pp. 288–295.
24. 24)
  - 10. Huang, L., Xie, C., Liu, J., et al: ‘Influence of catalysts on co-combustion of sewage sludge and water hyacinth blends as determined by TG-MS analysis’, Bioresour. Technol., 2018, 247, pp. 217–225.
25. 25)
  - 41. Wu, Z., Ohtsuka, Y.: ‘Nitrogen distribution in a fixed bed pyrolysis of coals with different ranks: formation and source of N2’, Energy Fuels, 1997, 11, pp. 477–482.
26. 26)
  - 31. Gong, Z., Wang, Z., Wang, Z., et al: ‘Study on the migration characteristics of nitrogen and sulfur during co-combustion of oil sludge char and microalgae residue’, Fuel, 2019, 238, pp. 1–9.
27. 27)
  - 33. Liu, J., Huang, L., Buyukada, M., et al: ‘Response surface optimization, modeling and uncertainty analysis of mass loss response of co-combustion of sewage sludge and water hyacinth’, Appl. Therm. Eng., 2017, 125, pp. 328–335.
28. 28)
  - 15. Sun, G., Zhang, G., Liu, J., et al: ‘(Co-) combustion behaviors and products of spent potlining and textile dyeing sludge’, J. Cleaner Prod., 2019, 224, pp. 384–395.
29. 29)
  - 7. Li, J., Hu, J., Wang, T., et al: ‘Thermogravimetric analysis of the co-combustion of residual petrochemical sludge and municipal sewage sludge’, Thermochim. Acta, 2019, 673, pp. 60–67.
30. 30)
  - 9. Chen, G.B., Chatelier, S., Lin, H.T., et al: ‘A study of sewage sludge co-combustion with Australian black coal and shiitake substrate’, Energies, 2018, 11, p. 3436.
31. 31)
  - 25. Flynn, J.H., Wall, L.A.: ‘General treatment of the thermogravimetry of polymers’, J. Res. Natl. Bur. Stand. A, Phys. Chem., 1966, 70A, (6), pp. 487–523.
32. 32)
  - 39. Moroń, W., Rybak, W.: ‘NOx and SO2 emissions of coals, biomass and their blends under different oxy-fuel atmospheres’, Atmos. Environ., 2015, 116, pp. 65–71.
33. 33)
  - 2. Kan, T., Strezov, V., Evans, T.: ‘Effect of the heating rate on the thermochemical behavior and biofuel properties of sewage sludge pyrolysis’, Energy Fuels, 2016, 30, pp. 1564–1570.
34. 34)
  - 29. Wang, C., Wang, X., Jiang, X., et al: ‘The thermal behavior and kinetics of co-combustion between sewage sludge and wheat straw’, Fuel Process. Technol., 2019, 189, pp. 1–14.
35. 35)
  - 18. Xie, W., Wen, S., Liu, J., et al: ‘Comparative thermogravimetric analyses of co-combustion of textile dyeing sludge and sugarcane bagasse in carbon dioxide/oxygen and nitrogen/oxygen atmospheres: thermal conversion characteristics, kinetics, and thermodynamics’, Bioresour. Technol., 2018, 255, pp. 88–95.
36. 36)
  - 26. Kim, Y.S., Kim, Y.S., Kim, S.H.: ‘Investigation of thermodynamic parameters in the thermal decomposition of plastic waste–waste lube oil compounds’, Environ. Sci. Technol., 2010, 44, pp. 5313–5317.
37. 37)
  - 27. Latchubugata, C.S., Kondapaneni, R.V., Patluri, K.K., et al: ‘Kinetics and optimization studies using Response Surface Matethodology in biodiesel production using heterogeneous catalyst’, Chem. Eng. Res. Des., 2018, 135, pp. 129–139.
38. 38)
  - 8. Peng, H., Li, Y., Chen, G., et al: ‘Co-combustion interactions between teak sawdust and sewage sludge with additives’, Bioresources, 2019, 14, pp. 1466–1481.
39. 39)
  - 32. Xie, Z., Ma, X.: ‘The thermal behaviour of the co-combustion between paper sludge and rice straw’, Bioresour. Technol., 2013, 146, pp. 611–618.
40. 40)
  - 35. Zhan, M., Sun, C., Chen, T., et al: ‘Emission characteristics for co-combustion of leather wastes, sewage sludge, and coal in a laboratory-scale entrained flow tube furnace’, Environ. Sci. Pollut. Res., 2019, 26, pp. 9707–9716.
41. 41)
  - 42. Yang, Z., Zhang, Y., Liu, L., et al: ‘Environmental investigation on co-combustion of sewage sludge and coal gangue: SO2, NOx and trace elements emissions’, Waste. Manag., 2016, 50, pp. 213–221.
42. 42)
  - 24. Ozawa, T.: ‘A new method of analyzing thermogravimetric data’, Bull. Chem. Soc. Jpn., 1965, 38, pp. 1881–1886.

Synergistic effects of co-combustion of sewage sludge and corn stalk and the resulting gas emission characteristics

References

Related content