The speed regulating differential mechanism (SRDM) enables grid-connected wind turbines (WTs) to generate constant-frequency electric power without fully- or partially-rated converters. In this study, the authors present a self-stabilising SRDM (SS-SRDM) consisting of a planetary gear train (PGT), a differential mechanism, and a constant speed motor for WTs to dislodge the high-cost speed sensors, servo motor and the complicated control system from the electrical controlled SRDM. The kinematic principles and the four-axis dynamic characteristics of SS-SRDM are studied. An effective parameter configuration method for tuning the speed ratios of five key connection units is also proposed and used to obtain a PGT with optimal structural parameters. The detailed simulation model of a 3 MW WT with SS-SRDM is established and then validated through physical experiments. Results show the satisfactory accuracy of the built model (maximum steady-state errors in output shaft and speed regulating shaft are, respectively, 0.76 and 1.95%). Finally, case studies and verification work of the proposed methods are carried out, in which the rotational speed, power, speed error, and power ratio among wind rotor, SRM, and synchronous generator are obtained. Case studies well-illustrate the availability of parameter design and the effectiveness of speed-regulations of the proposed SS-SRDM method.

References

1. 1)
  - 7. Chowdhury, M.A., Sayem, A.H.M., Shen, W.X., et al: ‘Robust active disturbance rejection controller design to improve low-voltage ride-through capability of doubly fed induction generator wind farms’, IET Renew. Power Gener., 2015, 9, (8), pp. 961–969.
2. 2)
  - 17. Yin, X.X., Lin, Y.G., Li, W., et al: ‘Hydro-viscous transmission based maximum power extraction control for continuously variable speed wind turbine with enhanced efficiency’, Renew. Energy, 2016, 87, pp. 646–655.
3. 3)
  - 16. Yin, X.X., Zhang, W.C., Zhao, X.W.: ‘Current status and future prospects of continuously variable speed wind turbines: a systematic review’, Mech. Syst. Signal Process., 2019, 120, pp. 326–340.
4. 4)
  - 26. Rui, X.M., Yin, W.L., Dong, Y.X., et al: ‘Fractional-order sliding mode control for hybrid drive wind power generation system with disturbances in the grid’, Wind Energy, 2019, 22, (1), pp. 49–64.
5. 5)
  - 28. Luo, M.Y.: ‘Planetary gear mechanism’ (Higher Education Press, Beijing, China, 1984), pp. 13–21.
6. 6)
  - 23. Rui, X.M., Su, R., Wu, X., et al: ‘The conceptual design of grid-connected WT based on speed regulating differential mechanism’, J. Mech. Sci. Technol., 2014, 28, (6), pp. 2015–2220.
7. 7)
  - 22. Lin, S., Zhao, X., Tong, X.: ‘Feasibility studies of a converter-free grid-connected offshore hydrostatic wind turbine’, IEEE Trans. Sustain. Energy, 2020, 11, (4), pp. 2494–2503.
8. 8)
  - 11. Rex, A.H., Johnson, K.E.: ‘Methods for controlling a wind turbine system with a continuously variable transmission in region 2’, J. Sol. Energy Eng.-T. ASME, 2009, 131, (3), pp. 121–128.
9. 9)
  - 19. Yin, X.X., Li, Y.G., Li, W.: ‘Operating modes and control strategy for megawatt-scale hydro-viscous transmission-based continuously variable speed wind turbines’, IEEE Trans. Sustain. Energy, 2015, 6, (4), pp. 1553–1564.
10. 10)
  - 27. Firoozian, R.: ‘Servo motors and industrial control theory (mechanical engineering series)’ (Springer, Germany, 2010).
11. 11)
  - 9. Mangialardi, L., Mantriota, G.: ‘The advantages of using continuously variable transmissions in wind power systems’, Renew. Energy, 1992, 2, (3), pp. 201–209.
12. 12)
  - 15. Giallanza, A., Porretto, M., Cannizzaro, L., et al: ‘Analysis of the maximization of wind turbine energy yield using a continuously variable transmission system’, Renew. Energy, 2017, 102, pp. 481–486.
13. 13)
  - 13. Zhao, X.Y., Maißer, P.: ‘A novel power splitting drive train for variable speed wind power generators’, Renew. Energy, 2003, 28, (13), pp. 2001–2011.
14. 14)
  - 25. Yin, W.L., Wu, X., Rui, X.M.: ‘Adaptive robust backstepping control of the speed regulating differential mechanism for wind turbines’, IEEE Trans. Sustain. Energy, 2019, 10, (3), pp. 1311–1318.
15. 15)
  - 14. Mu, A.L., Liu, H.Z., Zhang, M.H., et al: ‘Theory and kinematic analysis of a novel variable speed constant frequency wind energy conversion system’, Chin. J. Mech. Eng., 2008, 44, (1), pp. 196–204.
16. 16)
  - 24. Yin, W.L., Rui, X.M., Liu, L., et al: ‘Operating performance analysis on wind turbines with the speed regulating differential mechanism’, J. Renew. Sustain. Energy, 2018, 10, (6), p. 063301.
17. 17)
  - 20. Li, X., Dong, H.Y., Li, H., et al: ‘Optimization control of front-end speed regulation (FESR) wind turbine based on improved NSGA-II’, IEEE Access, 2019, 7, pp. 45583–45593.
18. 18)
  - 12. Jelaska, D., Podrug, S., Perkušić, M.: ‘A novel hybrid transmission for variable speed wind turbines’, Renew. Energy, 2015, 83, pp. 78–84.
19. 19)
  - 6. Carroll, J., McDonald, A., McMillan, D.: ‘Reliability comparison of wind turbines with DFIG and PMG drive trains’, IEEE Trans. Energy Convers., 2015, 30, (2), pp. 663–670.
20. 20)
  - 8. Zhang, F.S., Geng, Z.X., Yuan, W.: ‘The algorithm of interpolating windowed FFT for harmonic analysis of electric power system’, IEEE Trans. Power Deliv., 2001, 16, (2), pp. 160–164.
21. 21)
  - 3. Purvins, A., Zubaryeva, A., Llorente, M., et al: ‘Challenges and options for a large wind power uptake by the European electricity system’, Appl. Energy, 2011, 88, (5), pp. 1461–1469.
22. 22)
  - 1. He, D.X.: ‘Coping with climate change and China's wind energy sustainable development’, Adv. Climate Change Res., 2016, 7, (1), pp. 3–9.
23. 23)
  - 18. Liu, Q., Appunn, R., Hameyer, K.: ‘Wind turbine with mechanical power split transmission to reduce the power electronic devices: an experimental validation’, IEEE Trans. Ind. Electron., 2017, 64, (11), pp. 8811–8820.
24. 24)
  - 10. Idan, M., Lior, D.: ‘Continuously variable speed wind turbine transmission concept and robust control’, Wind Eng., 2000, 24, (3), pp. 151–167.
25. 25)
  - 2. Luo, F., Meng, K., Dong, Z.Y., et al: ‘Coordinated operational planning for wind farm with battery energy storage system’, IEEE Trans. Sustain. Energy, 2015, 6, (1), pp. 253–262.
26. 26)
  - 4. Tsili, M., Papathanassiou, S.: ‘A review of grid code technical requirements for wind farms’, IET Renew. Power Gener., 2009, 3, (3), pp. 308–332.
27. 27)
  - 21. Dong, H.Y., Chen, N., Li, X., et al: ‘Improved adaptive robust control for low voltage ride-through of front-end speed regulation wind turbine’, IEEE Access, 2020, 8, pp. 55438–55446.
28. 28)
  - 5. Waldner, M., Erlich, I.: ‘Variable speed wind turbines based on electromechanical differential systems’, IEEE Trans. Energy Convers., 2014, 29, (1), pp. 101–109.

Self-stabilising speed regulating differential mechanism for continuously variable speed wind power generation system

References

Related content