Design and implementation of two-phase permanent magnet synchronous motor fed by a matrix converter

Omur Aydogmus; Erkan Deniz

Design and implementation of two-phase permanent magnet synchronous motor fed by a matrix converter

View Fulltext

Author(s): Omur Aydogmus ¹ and Erkan Deniz ²
- Affiliations: 1: Mechatronics Engineering, Technology Faculty, Firat University, Elazig, Turkey ;
  2: Electric-Electronics Engineering, Technology Faculty, Firat University, Elazig, Turkey
Source: Volume 10, Issue 9, 28 July 2017, p. 1054 – 1060
DOI: 10.1049/iet-pel.2016.0705 , Print ISSN 1755-4535, Online ISSN 1755-4543

Received 02/09/2016, Accepted 29/03/2017, Revised 24/02/2017, Published 31/03/2017

A direct matrix converter structure and a two-phase permanent magnet synchronous motor (PMSM) are designed to increase the system efficiency in low-power motor drive applications. The drive system with two-phase PMSM has been proposed instead of the single-phase squirrel cage induction motor, which has low efficiency. A constant AC single-phase power supply can be directly converted to frequency and amplitude-adjustable two-phase power supply by the proposed converter structure. However, the proposed converter cannot generate the sufficient voltage level for a standard commercial motor. For this reason, a new two-phase PMSM is designed to adapt the converter output voltage amplitude with the motor-rated voltage by using Infolytica/MotorSolve software. A novel switching algorithm has been developed and analysed to show output voltage–current waveforms of the converter with their harmonic spectrum. In addition, the converter is designed compactly to be mounted to the terminal box of the designed motor. Experimental results have been obtained for speed control of the motor by using vector control at different reference speeds.

References

1. 1)
  - 4. Lettenmaier, T.A., Novotny, D.W., Lipo, T.A.: ‘Single-phase induction motor with an electronically controlled capacitor’, IEEE Trans. Ind. Applic., 1991, 27, (1), pp. 38–43.
2. 2)
  - 22. Azza, H.B., Jemli, M., Boussak, M., et al: ‘Implementation of sensorless speed control for two-phase induction motor drive using isfoc strategy’, IJST Trans. Electric. Eng., 2011, 35, (E1), pp. 63–74.
3. 3)
  - 19. Perez, J., Cardenas, V., Moran, L., et al: ‘Single-phase AC-AC converter operating as a dynamic voltage restorer’. 32nd IEEE Annual Conf. on Industrial Electronics, France, November 2006, pp. 1938–1943.
4. 4)
  - 9. Li, X., Su, M., Sun, Y., et al: ‘Modulation strategies based on mathematical construction method for matrix converter under unbalanced input voltages’, IET Power Electron., 2013, 6, (3), pp. 434–445.
5. 5)
  - 11. Sunter, S., Aydogmus, O.: ‘Implementation of a single-phase matrix converter induction motor drive’, Electric. Eng., 2008, 90, (6), pp. 425–433.
6. 6)
  - 17. Boztas, G., Sunter, S., Aydogmus, O.: ‘Modelling and simulation of 1-phase to 2-phase matrix converter motor drive’. 16th Int. Power Electronics and Motion Control Conf. and Exposition, Antalya, Turkey, May 2014, pp. 1014–1019.
7. 7)
  - 15. Khoei, A., Yuvarajan, S.: ‘Steady state performance of a single phase induction motor fed by a direct ac-ac converter’. IEEE Industry Applications Society Annual Meeting, October1989, vol. 1, pp. 128–132.
8. 8)
  - 6. Liu, T.H.: ‘A maximum torque control with a controlled capacitor for a single-phase induction motor’, IEEE Trans. Ind. Electron., 1995, 42, (1), pp. 17–24.
9. 9)
  - 20. Agarwal, V., Gupta, S.: ‘An efficient algorithm for generalised single-phase converter’, IET Power Electron., 2010, 3, (1), pp. 138–145.
10. 10)
  - 12. Idris, Z., Hamzah, M.K.: ‘Implementation of a new single-phase cycloconverter based on single-phase matrix converter topology using sinusoidal pulse width modulation with passive load condition’. 1st IEEE Conf. on Industrial Electronic and Applications, Singapore, May 2006, pp. 1–6.
11. 11)
  - 24. Blaabjerg, F., Lungeanu, F., Skaug, K., et al: ‘Two-phase induction motor drives low-cost topologies for TPIM drives in industrial applications’, IEEE Ind. Appl. Mag., 2004, 10, (4), pp. 24–32.
12. 12)
  - 2. Ghial, V.K., Saini, L.M., Saini, J.S.: ‘Parameter estimation of permanent-split capacitor-run single-phase induction motor using computed complex voltage ratio’, IEEE Trans. Ind. Electron., 2014, 61, (2), pp. 682–692.
13. 13)
  - 7. Blaabjerg, F., Lungeanu, F., Skaug, K., et al: ‘Two-phase induction motor drives’, IEEE Ind. Applic. Mag., 2004, 1, (4), pp. 24–32.
14. 14)
  - 8. Aydogmus, O., Deniz, E., Kayisli, K.: ‘PMSM drive fed by sliding mode controlled pfc boost converter’, Arab. J. Sci. Eng., 2014, 39, (6), pp. 4765–4773.
15. 15)
  - 1. Aydogmus, O., Deniz, E.: ‘Design of a two-phase pmsm fed by an ac-ac converter’. IEEE Int. Conf. on Industrial Technology (ICIT 2015), Seville, Spain, March 2015, pp. 690–695.
16. 16)
  - 21. Hamzah, M.K., Saidon, M.F., Noor, S.Z.M.: ‘Application of single phase matrix converter topology in uninterruptible power supply circuit incorporating unity power factor control’. IEEE 1st Conf. on Industrial Electronics and Applications, Singapore, May 2006, pp. 1–6.
17. 17)
  - 25. Jang, D.H., Yoon, D.Y.: ‘Space-vector PWM technique for two-phase inverter-fed two phase induction motors’, IEEE Trans. Ind. Applic., 2003, 39, (2), pp. 542–549.
18. 18)
  - 5. Muljadi, E., Zhao, Y., Liu, T.H., et al: ‘Adjustable ac capacitor for a single-phase induction motor’, IEEE Trans. Ind. Applic., 1993, 29, (3), pp. 479–485.
19. 19)
  - 23. Guerreiro, M., Foito, D., Cordeiro, A.: ‘A speed controller for a two-winding induction motor based on diametrical inversion’, IEEE Trans. Ind. Electron., 2010, 57, (1), pp. 449–456.
20. 20)
  - 3. Wang, J., Howe, D., Lin, Z.: ‘Design optimization of short-stroke single-phase tubular permanent-magnet motor for refrigeration applications’, IEEE Trans. Ind. Electron., 2010, 57, (1), pp. 327–334.
21. 21)
  - 28. Wallmark, O.: ‘Control of a permanent magnet synchronous motor with non-sinusoidal flux density distribution’. MSc thesis, Department of Electric Power Engineering, Chalmers University of Technology, Goteborg, Sweden, 2001.
22. 22)
  - 27. Aydogmus, O., Boztas, G., Sunter, S.: ‘Design of a novel single-phase in two-phase out matrix converter driving an induction motor’, IET Power Electron., 2016, 9, (7), pp. 1391–1397.
23. 23)
  - 14. Khoei, A., Yuvarajan, S.: ‘Single-phase AC-AC converters using power MOSFET's’, IEEE Trans. Ind. Electron., 1988, 35, (3), pp. 442–443.
24. 24)
  - 13. Zuckerberger, A., Weinstock, D., Alexandrovitz, A.: ‘Single-phase matrix converter’, IEE Proc. Electric Power Applic., 1997, 144, (4), pp. 235–240.
25. 25)
  - 16. Jacobina, C.B., Oliveira, T.M., Cabral da Silva, E.R.: ‘Control of the single-phase three-leg ac/ac converter’, IEEE Trans. Ind. Electron., 2006, 53, (2), pp. 467–476.
26. 26)
  - 10. Ozdemir, M., Sünter, S., Yurtseven, B.: ‘Modelling and simulation of a split-phase induction motor fed by single phase ac-ac converter’, Int. J. Eng. Model., 1999, 12, pp. 17–23.
27. 27)
  - 26. Jabbar, M.A., Khambadkone, A.M., Yanfeng, Z.: ‘Space-vector modulation in a two-phase induction motor drive for constant-power operation’, IEEE Trans. Ind. Electron., 2004, 51, (5), pp. 1081–1088.
28. 28)
  - 18. Quang, N.N., Stone, D.A., Bingham, C.M., et al: ‘Single phase matrix converter for radio frequency induction heating’. SPEEDAM'06 Int. Symp. on Power Electronics, Electrical Drives, Automation and Motion, Italy, May 2006, pp. 614–618.

Login

Not registered yet?

Share

Tools

Login to add to favourites

Key

Design and implementation of two-phase permanent magnet synchronous motor fed by a matrix converter

References

Related content