© The Institution of Engineering and Technology
The constant power control strategy of matrix converter (MC), which is commonly adopted in practice to suppress input disturbances, could result in system instability and oscillations of source currents and input voltages. To stabilise the system, a novel control method is proposed in this study, which is based on filtering the input voltages in stationary frame with digital high-pass filters of zero gain at the fundamental frequency. The filtered signals are injected to input currents so as to increase the input admittances for stability improvement. Since the filtered signals do not contain any fundamental frequency components, the proposed method would not affect the normal operation of MC. No matter the operation mode of MC is motoring or generating, the proposed method is always effective to improve system stability by adjusting the proportional coefficient and time constant of the digital filters. The feasibility and validity of the proposed method is verified by experimental results.
References
-
-
1)
-
3. Ortega, M., Jurado, F., Carpio, J.: ‘Control of indirect matrix converter with bidirectional output stage for micro-turbine’, IET Power Electron., 2012, 5, (6), pp. 659–668 (doi: 10.1049/iet-pel.2011.0210).
-
2)
-
27. Rivera, M., Rojas, C., Rodr′ıguez, J., et al: ‘Predictive current control with input filter resonance mitigation for a direct matrix converter’, IEEE Trans. Power Electron., 2011, 26, (10), pp. 2794–2803 (doi: 10.1109/TPEL.2011.2121920).
-
3)
-
25. Lei, J., Zhou, B., Qin, X., et al: ‘Active damping control strategy of matrix converter via modifying input reference currents’, IEEE Trans. Power Electron., 2015, 30, (9), p. 1 (doi: 10.1109/TPEL.2014.2365578).
-
4)
-
6. Li, X., Su, M., Sun, Y., Dan, H., Xiong, W.: ‘Modulation strategies based on mathematical construction method for matrix converter under unbalanced input voltages’, IET Power Electron., 2013, 6, (3), pp. 434–445 (doi: 10.1049/iet-pel.2012.0361).
-
5)
-
26. Rivera, M., Rodriguez, J., Wu, B., et al: ‘Current control for an indirect matrix converter with filter resonance mitigation’, IEEE Trans. Ind. Electron., 2012, 59, (1), pp. 71–79 (doi: 10.1109/TIE.2011.2165311).
-
6)
-
14. Yan, Y., Zhao, J., Xia, C., et al: ‘Direct torque control of matrix converter-fed permanent magnet synchronous motor drives based on master and slave vectors’, IET Power Electron., 2015, 8, (2), pp. 288–296 (doi: 10.1049/iet-pel.2014.0031).
-
7)
-
21. Trentin, A., Zanchetta, P., Wheeler, P.W., et al: ‘Automated optimal design of input filters for direct ac/ac matrix converters’, IEEE Trans. Ind. Electron., 2011, 59, (7), pp. 2811–2823 (doi: 10.1109/TIE.2011.2163283).
-
8)
-
11. Zhang, L., Watthanasarn, C., Shepherd, W.: ‘Control of AC–AC matrix converters for unbalanced and/or distorted supply voltage’. Proc. IEEE PESC, Vancouver, BC, Canada, June 17–21, 2001, Vol. 2, pp. 1108–1113.
-
9)
-
22. Andreu, J., Kortabarria, I., Ormaetxea, E., et al: ‘A step forward towards the development of reliable matrix converters’, IEEE Trans. Ind. Electron., 2012, 59, (1), pp. 167–183 (doi: 10.1109/TIE.2011.2146217).
-
10)
-
6. Díaz, M., Cárdenas, R., Rojas, F., et al: ‘3at-Phase 4-wire matrix converter-based voltage sag/swell generator to test low-voltage ride through in wind energy conversion systems’, IET Power Electron., 2014, 7, (12), (doi: 10.1049/iet-pel.2014.0065).
-
11)
-
29. Aredes, M., Akagi, H., Watanabe, E.H., et al: ‘Comparisons between the p-q and p-q-r theories in three-phase four-wire systems’, IEEE Trans. Power Electron., 2009, 24, (4), pp. 924–933 (doi: 10.1109/TPEL.2008.2008187).
-
12)
-
19. Liu, F., Klumpner, C., Blaabjerg, F.: ‘Stability analysis and experimental evaluation of a matrix converter drive’. Proc. 29th Annual IEEE IECON, Roanoke, VA, November 2003, pp. 2059–2065.
-
13)
-
23. Ruse, C.A.J., Clare, J.C., Klumpner, C.: ‘Numerical approach for guaranteeing stable design of practical matrix converter drive systems’. Proc. 32nd Annual IEEE Ind. Electron Conf., November 2006, pp. 2630–2635.
-
14)
-
9. Lozano-Garcia, J.M., Ramirez, J.M.: ‘Voltage compensator based on a direct matrix converter without energy storage’, IET Power Electron., 2015, 8, (3), pp. 321–332 (doi: 10.1049/iet-pel.2014.0099).
-
15)
-
20. Cardenas, P., Pena, R., Tobar, G., et al: ‘Stability analysis of a wind energy conversion system based on a doubly fed induction generator fed by a matrix converter’, IEEE Trans. Ind. Electron., 2009, 56, (10), pp. 4194–4206 (doi: 10.1109/TIE.2009.2027923).
-
16)
-
18. Dasgupta, A., Sensarma, P.: ‘Low-frequency dynamic modelling and control of matrix converter for power system applications’, IET Power Electron., 2012, 5, (3), pp. 304–314 (doi: 10.1049/iet-pel.2011.0106).
-
17)
-
2. Rodriguez, J., Rivera, M., Kolar, J.W., et al: ‘A review of control and modulation methods for matrix converters’, IEEE Trans. Ind. Electron., 2012, 59, (1), pp. 58–70 (doi: 10.1109/TIE.2011.2165310).
-
18)
-
14. Dasika, J., Saeedifard, M.: ‘An optimized space vector modulation strategy to control the matrix converter under unbalanced input conditions’, IEEE Trans. Ind. Electron., 2014, 0, (99), p. 1.
-
19)
-
10. Nielsen, P., Blaabjerg, F., Pedersen, J.K.: ‘Space vector modulated matrix converter with minimized number of switchings and a feedforward compensation of input voltage unbalance’. Proc. PEDES, 1996, pp. 833–839.
-
20)
-
15. Casadei, D., Serra, G., Tani, A., et al: ‘Theoretical and experimental investigation on the stability of matrix converters’, IEEE Trans. Ind. Electron., 2005, 52, (5), pp. 1409–1419 (doi: 10.1109/TIE.2005.855655).
-
21)
-
12. Yan, Y., An, H., Shi, T., et al: ‘Improved double line voltage synthesis of matrix converter for input current enhancement under unbalanced power supply’, IET Power Electron., 2013, 6, (4), pp. 798–808 (doi: 10.1049/iet-pel.2012.0588).
-
22)
-
11. Khoun Jahan, H., Banaei, M.R.: ‘Implementation of a stepped down frequency eight switches matrix converter suitable for micro-turbine generation’, IET Power Electron., 2014, 7, (5), pp. 1092–1098 (doi: 10.1049/iet-pel.2013.0419).
-
23)
-
17. Casadei, D., Serra, G., Tani, A., et al: ‘Effects of input voltage measurement on stability of matrix converter drive system’. Proc. Inst. Elect. Eng Conf., July 2004, vol. 151, pp. 487–497.
-
24)
-
21. Friedli, T., Kolar, J., Rodriguez, J., Wheeler, P.: ‘Comparative evaluation of three-phase ac/ac matrix converter and voltage dc-link back-to-back converter systems’, IEEE Trans. Ind. Electron., 2012, 59, (12), pp. 4487–4510 (doi: 10.1109/TIE.2011.2179278).
-
25)
-
6. Rajendran, S., Govindarajan, U., Parvathi Sankar, D.S.: ‘Active and reactive power regulation in grid connected wind energy systems with permanent magnet synchronous generator and matrix converter’, IET Power Electron., 2014, 7, (3), pp. 591–603 (doi: 10.1049/iet-pel.2013.0058).
-
26)
-
16. Sun, Y., Su, M., Li, X., et al: ‘A general constructive approach to matrix converter stabilization’, IEEE Trans. Ind. Electron., 2013, 28, (1), pp. 418–431.
-
27)
-
28. Haruna, J., Itoh, J.: ‘Control Strategy for a Matrix Converter with a Generator and a Motor’. Proc. 26th IEEE APEC, 2011, pp. 1782–1789.
-
28)
-
9. Rivera, M., Rojas, C., Wilson, A., Rodriguez, J.: ‘Review of predictive control methods to improve the input current of an indirect matrix converter’, IET Power Electron., 2014, 7, pp. 886–894 (doi: 10.1049/iet-pel.2013.0327).
-
29)
-
24. Wang, X., Lin, H., Feng, B., et al: ‘Damping of input LC filter resonance based on virtual resistor for matrix converter’. Proc. Energy Conversion Congress and Exposition (ECCE), 2012, pp. 5260–5271.
http://iet.metastore.ingenta.com/content/journals/10.1049/iet-pel.2015.0163
Related content
content/journals/10.1049/iet-pel.2015.0163
pub_keyword,iet_inspecKeyword,pub_concept
6
6