© The Institution of Engineering and Technology
A novel sectional linear driving method for light-emitting diode (LED) driver is studied. Considering several issues to be concerned in LED lighting applications, a complete introduction and analysis of the technique is proposed in this study. As the performance of the sectional linear LED driver can be affected by the LED distribution in each LED sub-string, a behavioural model is established to guide the design. Simulation results are obtained by utilising the behavioural model to optimise the output power and efficiency. The LED driver is fabricated with a 1 µm 5 V/20 V/500 V BCD technology, and a 15-W T-8 LED tube light prototype is established on the basis of the driver IC. A series of experiments are conducted to verify the theoretical analysis and the accuracy of the proposed model. The experimental data agrees with the simulation results, above 0.9 power factor (PF) and 90% efficiency are achieved with few peripheral components based on the design guidance made by the proposed model. Both the driving technique and the behavioural model are believed to be useful in the high efficiency, high PF, and cost-effective ac LED lighting applications.
References
-
-
1)
-
2. Loo, K.H., Lun, W.k., Tan, S.C., et al: ‘On driving techniques for LEDs: toward a generalized methodology’, IEEE Trans. Power Electron., 2009, 24, (12), pp. 2967–2976 (doi: 10.1109/TPEL.2009.2021183).
-
2)
-
9. Hwu, K.I., Tu, W.C., Lai, C.Y.: ‘Light-emitting diode driver with low-frequency ripple suppressed and dimming efficiency improved’, IET Power Electron., 2014, 7, (1), pp. 105–113 (doi: 10.1049/iet-pel.2013.0117).
-
3)
-
5. Chiu, H.J., Lo, Y.K., Chen, J.T., Cheng, S.J., Lin, C.Y., Mou, S.C.: ‘A high-efficiency dimmable led driver for low-power lighting application’, IEEE Trans. Ind. Electron., 2010, 57, (2), pp. 735–743 (doi: 10.1109/TIE.2009.2027251).
-
4)
-
3. Krames, M.R., Shchekin, O.B., Mach, R.M., et al: ‘Status and future of high-power light-emitting diodes for solid-state lighting’, J. Disp. Tech., 2007, 3, (2), pp. 160–175 (doi: 10.1109/JDT.2007.895339).
-
5)
-
16. Zhao, C., Xie, X., Liu, S.: ‘Multioutput LED drivers with precise passive current balancing’, IEEE Trans. Power Electron., 2013, 28, (3), pp. 1438–1448 (doi: 10.1109/TPEL.2012.2210562).
-
6)
-
26. Du, S.W., Zhu, F., Pei, Q.: ‘: ‘Primary side control circuit of a flyback converter for HBLED’. IEEE Int. Symp. on Power Electronics for Distributed Generation Systems, 2010, pp. 340–342.
-
7)
-
14. Xie, X., Wang, J., Zhao, C., Lu, Q.: ‘A novel output current estimation and regulation circuit for primary side controlled high power factor single-stage flyback LED driver’, IEEE Trans. Power Electron., 2012, 27, (11), pp. 4602–4612 (doi: 10.1109/TPEL.2012.2190523).
-
8)
-
29. Lai, C.M., Shyu, K.K.: ‘A single stage AC/DC converter based on zero voltage switching LLC resonant topology’, IET Electr. Power Appl., 2007, 1, (5), pp. 743–752 (doi: 10.1049/iet-epa:20060322).
-
9)
-
31. Lin, R.L., Liu, S.Y., Lee, C.C., et al: ‘Taylor-series-expression-based equivalent circuit models of LED for analysis of LED driver system’, IEEE Trans. Ind. Appl., 2013, 49, (4), pp. 1854–1862 (doi: 10.1109/TIA.2013.2258313).
-
10)
-
2. Zhang, F., Ni, J., Yu, Y.: ‘High power factor AC–DC LED driver with film capacitors’, IEEE Trans. Power Electron., 2013, 28, (11), pp. 4831–4840 (doi: 10.1109/TPEL.2012.2233498).
-
11)
-
8. Zhang, J.M., Zeng, H.L., Jiang, T.: ‘A primary-side control scheme for high-power-factor LED driver with TRIAC dimming capability’, IEEE Trans. Power Electron., 2012, 27, (11), pp. 4619–4629 (doi: 10.1109/TPEL.2012.2187341).
-
12)
-
16. Cheng, C.A., Cheng, H.L., Yang, F.L., et al: ‘Single-stage driver for supplying high-power light-emitting-diodes with universal utility-line input voltages’, IET Power Electron., 2012, 5, (9), pp. 1614–1623 (doi: 10.1049/iet-pel.2011.0478).
-
13)
-
11. Chen, W., Hui, S.Y.R.: ‘Elimination of an electrolytic capacitor in AC/DC light-emitting diode (LED) driver with high input power factor and constant output current’, IEEE Trans. Power Electron., 2012, 27, (3), pp. 1598–1606 (doi: 10.1109/TPEL.2010.2103959).
-
14)
-
15)
-
12. Wu, X., Zhang, J., Qian, Z.: ‘A simple two-channel LED driver with automatic precise current balancing’, IEEE Trans. Ind. Electron., 2011, 58, (10), pp. 4783–4788 (doi: 10.1109/TIE.2011.2109339).
-
16)
-
33. : ‘SMD LED, datasheet’ (Everlight Electronics., Ltd., Taipei County, Taiwan, 2013). .
-
17)
-
23. Lin, M.S., Chen, C.L.: ‘An LED driver with pulse current driving technique’, IEEE Trans. Power Electron., 2012, 27, (11), pp. 4594–4601 (doi: 10.1109/TPEL.2011.2182212).
-
18)
-
8. Ma, H., Lai, J.S., Feng, Q., et al: ‘A novel valley-fill sepic-derived power supply without electrolytic capacitors for LED lighting application’, IEEE Trans. Power Electron., 2012, 27, (6), pp. 3057–3071 (doi: 10.1109/TPEL.2011.2174446).
-
19)
-
32. Sedra, A.S., Smith, K.C.: ‘Microelectronic circuits’ (Oxford University Press, London, UK, 2004).
-
20)
-
4. Steigerwald, D.A., Bhat, J.C., Collins, D., et al: ‘Illumination with solid state lighting techonology’, IEEE J. Sel. Topics Quantum Electron., 2002, 8, (2), pp. 310–320 (doi: 10.1109/2944.999186).
-
21)
-
1. Lay-Ekuakille, A., D'Aniello, F., Miduri, F., et al: ‘Smart control of road-based LED fixures of energy saving’. Proc. IEEE Intelligent Data Acuisition Advanced Computing Systems, 2009, pp. 59–62.
-
22)
-
10. Hwu, K.I., Tu, W.C.: ‘Dimmable driver for light-emitting diode with total harmonic distortion improved’, IET Power Electron., 2012, 5, pp. 59–67 (doi: 10.1049/iet-pel.2011.0035).
-
23)
-
13. Hu, Y., Jovanović, M.M.: ‘LED driver with self-adaptive drive voltage’, IEEE Trans. Power Electron., 2008, 23, (6), pp. 3116–3124 (doi: 10.1109/TPEL.2008.2004558).
-
24)
-
7. Hussain, S., Lu, D.D.-C.: ‘A high-efficiency AC/DC converter with quasi-active power factor correction’, IEEE Trans. Power Electron., 2010, 25, (5), pp. 1103–1109 (doi: 10.1109/TPEL.2009.2037000).
-
25)
-
8. Ma, H., Zheng, C., Yu, W., Gu, B., Lai, J.S., Feng, Q.: ‘Bridgeless electrolytic capacitor-less valley-fill AC/DC converter for offline twin-bus light-emitting diode lighting application’, IET Power Electron., 2013, 6, (6), pp. 1132–1141 (doi: 10.1049/iet-pel.2012.0708).
-
26)
-
22. Rea, M.S.: ‘The IESNA Lighting Handbook’ (Illuminating Engineering Society of North America, New York, 2000), 9th edn.
-
27)
-
19. Li, Y.C., Chen, C.L.: ‘A novel single-stage high-power-factor AC-to-DC LED driving circuit with leakage inductance energy recycling’, IEEE Trans. Ind. Electron., 2012, 59, (2), pp. 793–801 (doi: 10.1109/TIE.2011.2151817).
-
28)
-
29)
-
9. Arias, M., Lamar, D.G., Sebastian, J., et al: ‘High-efficiency LED driver without electrolytic capacitor for street lighting’, IEEE Trans. Ind. Appl., 2013, 49, (1), pp. 127–137 (doi: 10.1109/TIA.2012.2227644).
-
30)
-
1. Singh, B., Shrivastava, A.: ‘Buck converter-based power supply design for low power light emitting diode lamp lighting’, IET Power Electron., 2014, 7, (4), pp. 946–956 (doi: 10.1049/iet-pel.2013.0391).
-
31)
-
3. Wang, Y., Guan, Y., Liang, X., Wang, W., Xu, D.: ‘Two-stage LED street lighting system based on a novel single-stage AC/DC converter’, IET Power Electron., 2014, 7, (6), pp. 1374–1383 (doi: 10.1049/iet-pel.2013.0540).
-
32)
-
7. Wang, S., Ruan, X., Yao, K., et al: ‘A flicker-free electrolytic capacitor-less AC-DC LED Driver’, IEEE Trans. Power Electron., 2012, 27, (11), pp. 4540–4548 (doi: 10.1109/TPEL.2011.2180026).
-
33)
-
24. Veitch, J.A., McColl, S.L.: ‘Modulation of fluorescent light: flicker rate and light source effects on visual performance and visual comfort’, Light. Res. Technol., 1995, 27, (4), pp. 243–256 (doi: 10.1177/14771535950270040301).
http://iet.metastore.ingenta.com/content/journals/10.1049/iet-pel.2015.0060
Related content
content/journals/10.1049/iet-pel.2015.0060
pub_keyword,iet_inspecKeyword,pub_concept
6
6