Unified power quality conditioner allocation for reactive power compensation of radial distribution networks

Sanjib Ganguly

Unified power quality conditioner allocation for reactive power compensation of radial distribution networks

View Fulltext

Author(s): Sanjib Ganguly ¹
- Affiliations: 1: Department of Electrical Engineering, National Institute of Technology, Rourkela 769 008, India
Source: Volume 8, Issue 8, August 2014, p. 1418 – 1429
DOI: 10.1049/iet-gtd.2013.0382 , Print ISSN 1751-8687, Online ISSN 1751-8695

Received 04/06/2013, Accepted 20/01/2014, Revised 06/12/2013, Published 25/02/2014

This paper presents an investigative study on unified power quality conditioner (UPQC) allocation for reactive power compensation of radial distribution networks. An UPQC consists of a series and a shunt inverter. The UPQC model based on phase angle control (UPQC-PAC) is used. In UPQC-PAC, the series inverter injects a voltage with controllable phase angle in such a way that the voltage magnitude at load end remains unchanged. Owing to the phase angle shift, the series inverter participates in load reactive power compensation along with the shunt inverter during healthy operating condition. The UPQC-PAC model is suitably modified so as to provide the reactive power compensation of a distribution network. The impact of the UPQC-PAC allocation is studied by placing it at each bus of a network, except the substation bus, one at a time. A load flow algorithm including the UPQC-PAC model is devised and used in the determination of its optimal location in a network. The simulation study shows that the optimal allocation of UPQC-PAC results in significant amount of power loss reduction, under voltage mitigation, and enhancement of voltage stability margin. Better power loss and bus voltage are obtained with UPQC-PAC compared with some existing reactive power compensation approaches.

References

1. 1)
  - 29. Ramalinga Raju, M., Ramachandra Murthy, K.V.S., Ravindra, K.: ‘Direct search algorithm for capacitive compensation in radial distribution systems’, Int. J. Electr. Power Energy Syst., 2012, 42, pp. 24–30 (doi: 10.1016/j.ijepes.2012.03.006).
2. 2)
  - B. Han , B. Bae , H. Kim , S. Baek . Combined operation of unified power-quality conditioner with distributed generation. IEEE Trans. Power Deliv. , 1 , 330 - 338
3. 3)
  - 10. Khadkikar, V., Chandra, A.: ‘UPQC-S: a novel concept of simultaneous voltage sag/swell and load reactive power compensations utilizing series inverter of UPQC’, IEEE Trans. Power Electron., 2011, 26, (9), pp. 2414–2425 (doi: 10.1109/TPEL.2011.2106222).
4. 4)
  - 12. Khadkikar, V., Chandra, A.: ‘A novel structure for three-phase four-wire distribution system utilizing unified power quality conditioner (UPQC)’, IEEE Trans. Ind. Appl., 2009, 45, pp. 1897–1902 (doi: 10.1109/TIA.2009.2027147).
5. 5)
  - 17. Karanki, S.B., Mishra, M.K., Kumar, B.K.: ‘Particle swarm optimization-based feedback controller for unified power-quality conditioner’, IEEE Trans. Power Deliv., 2010, 25, (4), pp. 2814–2824 (doi: 10.1109/TPWRD.2010.2047873).
6. 6)
  - A.K. Jindal , A. Ghosh , A. Joshi . Interline unified power quality conditioner. IEEE Trans. Power Deliv. , 1 , 364 - 372
7. 7)
  - M. Chis , M.M.A. Salama , S. Jayaaam . Capacitor placement in distribution systems using heuristic search strategies. IEE Proc., Gener. Transm. Distrib , 3 , 225 - 230
8. 8)
  - D. Thukaram , H. Khincha , H. Vijaynarasimha . Artificial neural network and support vector machine approach for locating faults in radial distribution systems. IEEE Trans. Power Deliv. , 2 , 710 - 721
9. 9)
  - 18. Heydari, H., Moghadasi, A.H.: ‘Optimization scheme in combinatorial UPQC and SFCL using normalized simulated annealing’, IEEE Trans. Power Deliv., 2011, 26, (3), pp. 1489–1498 (doi: 10.1109/TPWRD.2011.2111390).
10. 10)
  - 27. Savier, J.S., Das, D.: ‘Impact of network reconfiguration on loss allocation of radial distribution systems’, IEEE Trans. Power Deliv., 2007, 22, (4), pp. 2473–2480 (doi: 10.1109/TPWRD.2007.905370).
11. 11)
  - A. Ghosh , G. Ledwich . A unified power quality conditioner (UPQC) for simultaneous voltage and current compensation. Electr. Power Syst. Res. , 1 , 55 - 63
12. 12)
  - H. Fujita , H. Akagi . The unified power quality conditioner: the integration of series and shunt-active filters. IEEE Trans. Power Electron. , 2 , 315 - 322
13. 13)
  - R.H. Liang , Y.Sh. Wang . Fuzzy-based reactive power and voltage control in a distribution system. IEEE Trans. Power Deliv. , 610 - 618
14. 14)
  - 4. Deshmukh, S., Natarajan, B., Pahwa, A.: ‘Voltage/VAR control in distribution networks via reactive power injection through distributed generators’, IEEE Trans. Smart Grid, 2012, 3, (3), pp. 1226–1234 (doi: 10.1109/TSG.2012.2196528).
15. 15)
  - 20. Jayanti, N.G., Basu, M., Conlon, M.F., Gaughan, K.: ‘Rating requirements of the unified power quality conditioner to integrate the fixed speed induction generator-type wind generation to the grid’, IET Renew. Power Gener., 2009, 3, (2), pp. 133–143 (doi: 10.1049/iet-rpg:20080009).
16. 16)
  - 5. Dadkhah, M., Venkatesh, B.: ‘Cumulant based stochastic reactive power planning method for distribution systems with wind generators’, IEEE Trans. Power Syst., 2012, 27, (4), pp. 2351–2359 (doi: 10.1109/TPWRS.2012.2210569).
17. 17)
  - S. Ghosh , D. Das . Method of load -flow solution of radial distribution networks. IEE Proc., Gener., Transm. Distrib. , 6 , 641 - 648
18. 18)
  - 24. Khadkikar, V., Chandra, A., Barry, A.O., Nguyen, T.D.: ‘Analysis of power flow in UPQC during voltage sag and swell conditions for selection of device ratings’. IEEE Proc.Canadian Conf. Electrical and Computer Engineering, Ottawa, 2006, pp. 867–872.
19. 19)
  - 14. Brenna, M., Faranda, R., Tironi, E.: ‘A new proposal for power quality and custom power improvement: OPEN UPQC’, IEEE Trans. Power Deliv., 2009, 24, (4), pp. 2107–2116 (doi: 10.1109/TPWRD.2009.2028791).
20. 20)
  - 6. Jazebi, S., Hosseinian, S.H., Vahidi, B.: ‘DSTATCOM allocation in distribution networks considering reconfiguration using differential evolution algorithm’, Energy Convers. Manage., 2011, 52, pp. 2777–2783 (doi: 10.1016/j.enconman.2011.01.006).
21. 21)
  - 7. Khadkikar, V.: ‘Enhancing electric power quality using UPQC: a comprehensive overview’, IEEE Trans. Power Electron., 2012, 27, (5), pp. 2284–2297 (doi: 10.1109/TPEL.2011.2172001).
22. 22)
  - M. Basu , S.P. Das , G.K. Dubey . Comparative evaluation of two models of UPQC for suitable interface to enhance power quality. Electr. Power Syst. Res. , 821 - 830
23. 23)
  - 13. Al Abri, R.S., El-Saadany, E.F., Atwa, Y.M.: ‘Optimal placement and sizing method to improve the voltage stability margin in a distribution system using distributed generation’, IEEE Trans. Power Syst., 2013, 28, (1), pp. 326–334 (doi: 10.1109/TPWRS.2012.2200049).
24. 24)
  - 22. Kennedy, J., Eberhart, R.C.: ‘Particle swarm optimization’. Proc. IEEE Int. Conf. Neural Networks, Perth, Australia, 1995, pp. 1942–1948.
25. 25)
  - 21. Hosseini, M., Shayanfar, H.A., Fotuhi-Firuzabad, M.: ‘Modeling of unified power quality conditioner (UPQC) in distribution systems load flow’, Energy Convers. Manage., 2009, 50, pp. 1578–1585 (doi: 10.1016/j.enconman.2009.02.006).
26. 26)
  - Y. del Valle , G.K. Venayagamoorthy , S. Mohagheghi , J.C. Hernandez , R.G. Harley . Particle swarm optimization: basic concepts, variants and applications in power systems. IEEE Trans. Evol. Comput. , 2 , 171 - 195
27. 27)
  - V. Khadkikar , A. Chandra . A new control philosophy for a unified power quality conditioner (UPQC) to coordinate load-reactive power demand between shunt and series inverters. IEEE Trans. Power Deliv. , 4 , 2522 - 2534
28. 28)
  - M.E. Baran , F.F. Wu . Network reconfiguration in distribution systems for loss reduction and load balancing. IEEE Trans. Power Del. , 1401 - 1407
29. 29)
  - D. Das . Reactive power compensation for radial distribution networks using genetic algorithm. Int. J. Electr. Power Energy Syst. , 7 , 573 - 581
30. 30)
  - 11. Kisck, D.O., Navrapescu, V., Kisck, M.: ‘Single-phase unified power quality conditioner with optimum voltage angle injection for minimum VA requirement’. IEEE Proc.Power Electronics Specialists Conf., Bucharest, 2007, pp. 574–579.

Login

Not registered yet?

Share

Tools

Login to add to favourites

Key

Unified power quality conditioner allocation for reactive power compensation of radial distribution networks

References

Related content