http://iet.metastore.ingenta.com
1887

Analytical model for energy recovery circuit of plasma display panel data driver integrated circuit

Analytical model for energy recovery circuit of plasma display panel data driver integrated circuit

For access to this article, please select a purchase option:

Buy article PDF
£12.50
(plus tax if applicable)
Buy Knowledge Pack
10 articles for £75.00
(plus taxes if applicable)

IET members benefit from discounts to all IET publications and free access to E&T Magazine. If you are an IET member, log in to your account and the discounts will automatically be applied.

Learn more about IET membership 

Recommend Title Publication to library

You must fill out fields marked with: *

Librarian details
Name:*
Email:*
Your details
Name:*
Email:*
Department:*
Why are you recommending this title?
Select reason:
 
 
 
 
 
IET Circuits, Devices & Systems — Recommend this title to your library

Thank you

Your recommendation has been sent to your librarian.

An analytical model is proposed to analyse the energy recovery circuit (ERC) efficiency of plasma display panel (PDP) data driver integrated circuit (IC). The experimental measurements agree with the analysis results very well. The analysis results show that the ERC efficiency of PDP data driver IC is influenced by three factors: the value of charge time T ERC, the channel resistor R on and the capacitance of C L. The range of T ERC is restricted in actual PDP system. C L is determined by physical parameters of PDP panel, and its value is nearly changeless. Therefore the ERC efficiency of PDP data driver IC can be improved significantly by using superior DPLD (double-channel p-type lateral extended drain metal oxidesemi conductor) transistor that has smaller R on.

References

    1. 1)
      • 1. Lee, K.-Y., Chao, P.-C.P.: ‘A new AMOLED pixel circuit with pulsed drive and reverse bias to alleviate OLED degradation’, IEEE Trans. Electron. Dev., 2012, 59, (4), p. 1123 (doi: 10.1109/TED.2012.2184289).
    2. 2)
      • 2. http://www.valueelectronics.com/, accessed July 2012.
    3. 3)
      • 3. http://www.displaybank.com/, accessed June 2012.
    4. 4)
      • 4. Na, Y., Hwang, S.J., Min, J., Kim, T., Kim, S.W.: ‘A processor-based decoupled timing controller for flexible and low-cost 2D/3D plasma display panel design’, IEEE Trans. Consum. Electron., 2011, 57, (1), pp. 19 (doi: 10.1109/TCE.2011.5735476).
    5. 5)
      • 5. Zhang, X.-N., Liu, C.-L., Tu, Z.-T., Zhang, J.: ‘Analysis of the address power in PDPs with a newly developed equivalent circuit model’, IEEE Trans. Consum. Electron., 2007, 53, (2), pp. 243248 (doi: 10.1109/TCE.2007.381681).
    6. 6)
      • 6. Li, J., He, X., Xu, S., Sun, W.: ‘A review of energy recovery circuits for plasma display panels’, IETE Tech. Rev., 2011, 28, (1), pp. 40 (doi: 10.4103/0256-4602.74504).
    7. 7)
      • 7. Kwak, S.: ‘A review of switch-mode sustain drivers with resonant networks for plasma display panels’, IEEE Trans. Ind. Electron., 2010, 57, (5), pp. 16241625 (doi: 10.1109/TIE.2009.2032199).
    8. 8)
      • 8. Liu, C.-C., Chen, C.-L., Lee, K.-M.: ‘A novel energy-recovery sustaining driver for plasma display panel’, IEEE Trans. Ind. Electron., 2000, 47, (6), pp. 12711277 (doi: 10.1109/41.887955).
    9. 9)
      • 9. Han, S.-K., Youn, M.-J.: ‘High performance and low cost single switch current fed energy-recovery circuit for AC plasma display panel’, IEEE Trans. Power Electron., 2007, 22, (2), pp. 338345 (doi: 10.1109/TPEL.2006.890007).
    10. 10)
      • 10. Han, S.-K., Moon, G.-W., Moon, G.-W.: ‘A resonant energy-recovery circuit for plasma display panel employing gas-discharge current compensation method’, IEEE Trans. Power Electron., 2005, 20, (1), pp. 209217 (doi: 10.1109/TPEL.2004.839803).
    11. 11)
      • 11. Liu, C.-C., Hsu, H.-B., Lo, S.-T., Chen, C.-L.: ‘An energy-recovery sustaining driver with discharge current compensation for AC plasma display panel’, IEEE Trans. Ind. Electron., 2001, 48, (2), pp. 344351 (doi: 10.1109/41.915413).
    12. 12)
      • 12. Yang, J.H., Kim, J.K., Whang, K.W.: ‘An energy recovery circuit for ac plasma display panel with series CLC resonance-SER1’, IEEE Trans. Consum. Electron., 2005, 51, (2), pp. 718724 (doi: 10.1109/TCE.2005.1468024).
    13. 13)
      • 13. Kwak, S., Jung, J.-W., Lee, D.-M., Cho, T.-S.: ‘A new sustain driver with energy recovery circuit based on low-voltage components and low-voltage power supply for AC plasma display panel’, IEEE Trans. Consum. Electron., 2008, 54, (3), pp. 13211328 (doi: 10.1109/TCE.2008.4637623).
    14. 14)
      • 14. van der Broeck, H., Wendt, M.: ‘Alternative sustain driver concepts for plasma display panels’. Proc. IEEE PESC, 2004, pp. 26722677.
    15. 15)
      • 15. Meng, L.-G., Liang, Z.-H., Liu, C.-L.: ‘Energy recovery circuit with auxiliary power supply for AC plasma display panel’, IEEE Trans. Consum. Electron., 2007, 53, (2), pp. 765768 (doi: 10.1109/TCE.2007.381757).
    16. 16)
      • 16. Park, J.-K., Do, H.-D., Kwon, B.-H.: ‘Asymmetric current buildup sustainer for AC plasma display panel’, IEEE Trans. Ind. Electron., 2008, 55, (4), pp. 18631870 (doi: 10.1109/TIE.2007.909062).
    17. 17)
      • 17. Choi, B.-D.: ‘Enhancement of current driving capability in data driver ICs for plasma display panels’, IEEE Trans. Consum. Electron., 2009, 55, (3), pp. 992997 (doi: 10.1109/TCE.2009.5278054).
    18. 18)
      • 18. Qian, Q., Sun, W., Li, H., Wu, H., Shi, L.: ‘Reliability investigations and improvements of the pLEDMOS for PDP data driver ICs’, Semicond. Sci. Technol., 2011, 26, (5), pp. 16 (doi: 10.1088/0268-1242/26/5/055001).
http://iet.metastore.ingenta.com/content/journals/10.1049/iet-cds.2012.0249
Loading

Related content

content/journals/10.1049/iet-cds.2012.0249
pub_keyword,iet_inspecKeyword,pub_concept
6
6
Loading
This is a required field
Please enter a valid email address