© The Institution of Electrical Engineers
La théorie des mailles parallélipipédiques et du changement de maille dans la méthode TLM est exposée. Des résultats sont donnés pour des structures fin-line en cavité. Le temps de calcul est réduit dans un rapport considérable pour de nombreux problèmes.The letter shows how the introduction of parallelepiped meshes and a variable-size mesh into the original three-dimensional TLM method leads to a dramatic reduction of the CPU time needed. The theoretical aspects of these modifications are given, as well as some numerical results obtained for ‘fin-line’ structures in a cavity.
References
-
-
1)
-
P. Saguet ,
E. Pic
.
Le maillage rectangulaire et le changement de maille dans la méthode TLM en 2 dimensions.
Electron. Lett.
,
227 -
279
-
2)
-
P.B. Jöhns ,
R.L. Beurlé
.
Numerical solution of two dimensional scattering problems using a transmission line matrix.
Proc. IEE
,
1203 -
1208
-
3)
-
P. Saguet ,
E. Pic
.
Utilisation d'un nouveau type de noeud dans la méthode TLM en 3 dimensions.
Electron. Lett.
,
478 -
480
-
4)
-
Akhtarzad, S.: `Analysis of lossy microwave structures and microstrip resonators by TLM method', 1975, Ph.D. thesis, , Nottingham.
-
5)
-
Hoefer, W.J.R., Ros, A.: `Fin-line parameters calculated with TLM method', IEEE MTT-S Int. Mic. Symp., April–May 1979, .
http://iet.metastore.ingenta.com/content/journals/10.1049/el_19840148
Related content
content/journals/10.1049/el_19840148
pub_keyword,iet_inspecKeyword,pub_concept
6
6