This is an open access article published by the IET under the Creative Commons Attribution License (http://creativecommons.org/licenses/by/3.0/)
The lightning energy can be very harmful to wind turbine (WT) farm components; therefore an effective lightning protection technique is required. In this study, a novel technique for WT components protection is presented. This technique used ferromagnetic rings placed around the WT blade roots. Ferrite ring was moulded into particular shapes from the powder of compounds of ferric oxide, manganese, and zinc, and then sintered. The dimensions of rings used are 990 mm (inner diameter), 1030 mm (outer diameter), and 100 mm (thickness). The effectiveness of the novel technique in overvoltage mitigation during lightning strokes is presented and discussed. The results show that the overvoltage is effectively damped with using this technique. The transient overvoltage at control devices is reduced to 16% of its original value, while at distribution system; it is reduced to 5% of its original value.
References
-
-
1)
-
7. Abd-Allah, M.A., Ali, M.N., Said, A.: ‘A proper design of wind turbine grounding systems under lightning’, World Acad. Sci. Eng. Technol. Int. Sci. Index 94, Int. J. Electric. Robot. Electron. Commun. Eng., 2014, 8, (10), pp. 1358–1365.
-
2)
-
15. Zhu, J.G., Hui, S.Y.R., Ramsden, V.S.: ‘Discrete modeling of magnetic cores including hysteresis, eddy current and anomalous losses’, Proc. Inst. Elect. Eng. A, Sci. Meas. Technol. IET, 1993, 140, (4), pp. 317–322 (doi: 10.1049/ip-a-3.1993.0048).
-
3)
-
3. Abd-Allah, M.A., Said, A., Ali, M.N.: ‘Mitigation of lightning hazards at the more sensitive points in wind farms using ant-colony optimization technique’, Int. Electric. Eng. J. (IEEJ), 2015, 6, (4), pp. 1856–1868.
-
4)
-
3. Yasuda, Y., Uno, N., Kobayashi, H., et al: ‘Surge analysis on wind farm when winter lightning strikes’, IEEE Trans. Energy Convers., 2008, 23, (1), pp. 257–262 (doi: 10.1109/TEC.2007.905361).
-
5)
-
6)
-
5. Abd-Allah, M.A., Ali, M.N., Said, A.: ‘Effective factors on the generated transient voltage in the wind farm due to lightning’, TELKOMNIKA Indonesian J. Electric. Eng., 2015, 13, (1), pp. 42–56 (doi: 10.11591/telkomnika.v13i1.6844).
-
7)
-
12. Kazimierczuk, M.K.: ‘High-frequency magnetic components’ (Wiley, Dayton, Ohio, USA, 2014).
-
8)
-
6. Abd-Allah, M.A., Ali, M.N., Said, A.: ‘Towards an accurate modeling of frequency-dependent wind farm components under transient conditions’, WSEAS Trans. Power Syst., 2014, 9, pp. 395–407, .
-
9)
-
2. Jiang, J.-L., Chang, H.-C., Kuo, C.-C., et al: ‘Transient overvoltage phenomena on the control system of wind turbines due to lightning strike’, Renew. Energy, 2013, 57, pp. 181–189 (doi: 10.1016/j.renene.2013.01.020).
-
10)
-
14. O'Handley, R.C.: ‘Modern magnetic materials’ (Wiley, 2000).
-
11)
-
10. Martinez, A.J.: ‘Statistics assessment of very fast transient overvoltages in gas insulated substations’. IEEE Power Engineering Society Summer Meeting, 2000, vol. 2, pp. 882–883.
-
12)
-
9. Paolone, M., Napolitano, F., Borghetti, A., et al: ‘Models of wind-turbine main shaft bearings for the development of specific lightning protection systems’. IEEE Conf. on Power Tech, Lausanne, July 2007.
-
13)
-
13. Burgerhartstraat, S.: ‘Handbook of magnetic materials’ (Elsevier Science B.V, Amsterdam, 1997), vol. 10.
-
14)
-
15)
http://iet.metastore.ingenta.com/content/journals/10.1049/joe.2015.0175
Related content
content/journals/10.1049/joe.2015.0175
pub_keyword,iet_inspecKeyword,pub_concept
6
6