This is an open access article published by the IET under the Creative Commons Attribution-NoDerivs License (http://creativecommons.org/licenses/by-nd/3.0/)
A novel integrated motor drive and non-isolated battery charger based on a split-phase permanent magnet (PM) motor is presented and described for a plug-in vehicle. The motor windings are reconfigured by a relay for the traction and charging operation. In traction mode, the motor is like a normal three-phase motor, whereas in the charging mode, after windings reconnection, the system is a three-phase Boost rectifier. One important challenge to use the motor as three inductors in charger circuit is to have it in standstill during the battery charging. Based on the presented mathematical model of a split-phase PM motor, the zero-torque condition of the motor is explained which led to a proper windings reconnection for the charging. Simulation and experimental results of two separate practical systems are provided to verify the proposed integrated battery charger. Some practical limitations and design recommendations are provided to achieve a more realistic practical system.
References
-
-
1)
-
12. Haghbin, S., Lundmark, S., Alakula, M., Carlson, O.: ‘An isolated high-power integrated charger in electrified-vehicle applications’, IEEE Trans. Veh. Technol., 2011, 60, (9), pp. 4115–4126 (doi: 10.1109/TVT.2011.2162258).
-
2)
-
9. Haghbin, S., Lundmark, S., Alakula, M., et al: ‘Grid-connected integrated battery chargers in vehicle applications: review and new solution’, IEEE Trans. Ind. Electron., 2013, 60, (2), pp. 459–473 (doi: 10.1109/TIE.2012.2187414).
-
3)
-
10. Haghbin, S., Khan, K., Zhao, S., Alakula, M., Lundmark, S., Carlson, O.: ‘An integrated 20-kW motor drive and isolated battery charger for plug-in vehicles’, IEEE Trans. Power Electron., 2013, 28, (8), pp. 4013–4029 (doi: 10.1109/TPEL.2012.2230274).
-
4)
-
4. Yilmaz, M., Krein, P.T.: ‘Review of battery charger topologies, charging power levels, and infrastructure for plug-in electric and hybrid vehicles’, IEEE Trans. Power Electron., 2013, 28, (5), pp. 2151–2169 (doi: 10.1109/TPEL.2012.2212917).
-
5)
-
10. Solero, L.: ‘Nonconventional on-board charger for electric vehicle propulsion batteries’, IEEE Trans. Veh. Technol., 2001, 50, (1), pp. 144–149 (doi: 10.1109/25.917904).
-
6)
-
3. Singh, B., Singh, B.N., Chandra, A., Al-Haddad, K., Pandey, A., Kothari, D.P.: ‘A review of single-phase improved power quality AC–DC converters’, IEEE Trans. Ind. Electron., 2003, 50, pp. 962–981 (doi: 10.1109/TIE.2003.817609).
-
7)
-
16. Estima, J., Marques Cardoso, A.: ‘Efficiency analysis of drive train topologies applied to electric/hybrid vehicles’, IEEE Trans. Veh. Technol. , 2012, 61, (3), pp. 1021–1031 (doi: 10.1109/TVT.2012.2186993).
-
8)
-
2. Singh, B., Singh, B.N., Chandra, A., et al: ‘A review of three-phase improved power quality ac-dc converters’, IEEE Trans. Ind. Electron., 2004, 51, (3), pp. 641–660 (doi: 10.1109/TIE.2004.825341).
-
9)
-
10)
-
8. Bruyère, A., De Sousa, L., Bouchez, B., Sandulescu, P., Kestelyn, X., Semail, E.: ‘A multiphase traction/fast-battery-charger drive for electric or plug-in hybrid vehicles’. IEEE Vehicle Power and Propulsion Conf. (VPPC) Proc. 2010, France, October 2010.
-
11)
-
1. Haghbin, S.: ‘Integrated motor drives and battery chargers for electric or plug-in hybrid electric vehicles’. , Chalmers University of Technology, 2013.
-
12)
-
23. Mohan, N., Undeland, M.T., Robbins, W.P.: ‘Power electronics: converters, applications, and design’ (John Wiley and Sons, 1995).
-
13)
-
13. Haghbin, S., Khan, K., Zhao, S., Alakula, M., Lundmark, S., Carlson, O.: ‘An integrated 20-kw motor drive and isolated battery charger for plug-in vehicles’, IEEE Trans. Power Electron., 2013, 28, (8), pp. 4013–4029 (doi: 10.1109/TPEL.2012.2230274).
-
14)
-
15. Yilmaz, M., Krein, P.: ‘Review of battery charger topologies, charging power levels and infrastructure for plug-in electric and hybrid vehicles’, IEEE Trans. Power Electron., 2012, 28, (5), pp. 2151–2169 (doi: 10.1109/TPEL.2012.2212917).
-
15)
-
20. Malinowski, M.: ‘Sensorless control strategies for three-phase pwm rectifiers’. , Faculty of Electrical Engineering, Institute of Control and Industrial Electronics, Warsaw University of Technology, 2001.
-
16)
-
22. Mandiola, J., Carmona, D., Haghbin, S., Abdulahovic, T., Ellsen, M.: ‘An FPGA implementation of a voltage-oriented controlled three-phase PWM boost rectifier’. Electrical Systems for Aircraft, Railway and Ship Propulsion (ESARS), 2012, October 2012, pp. 1–6.
-
17)
-
L. Solero
.
Nonconventional on-board charger for electric vehicle propulsion batteries.
IEEE Trans. Veh. Technol.
,
1 ,
144 -
149
-
18)
-
9. Lacroix, S., Laboure, E., Hilairet, M.: ‘An integrated fast battery charger for electric vehicle’. IEEE Vehicle Power and Propulsion Conf. (VPPC) Proc. 2010, France, October 2010.
-
19)
-
12. Haghbin, S., Lundmark, S., Alakula, M., Carlson, O.: ‘An isolated high-power integrated charger in electrified-vehicle applications’, IEEE Trans. Veh. Technol., 2011, 60, (9), pp. 4115–4126 (doi: 10.1109/TVT.2011.2162258).
-
20)
-
B. Singh ,
B.N. Singh ,
A. Chandra ,
K. Al-Haddad ,
A. Pandey ,
D.P. Kothari
.
A review of three-phase improved power quality AC–DC converters.
IEEE Trans. Ind. Electron.
,
641 -
660
-
21)
-
4. Cocconi, A.G.: ‘Combined motor drive and battery recharge system’. , 23 August 1994.
-
22)
-
5. Rippel, W.E.: ‘Integrated traction inverter and battery charger apparatus’. , 24 April 1990.
-
23)
-
B. Singh ,
B.N. Singh ,
A. Chandra ,
K. Al-Haddad ,
A. Pandey ,
D.P. Kothari
.
A review of single-phase improved power quality AC-DC converters.
IEEE Trans. Ind. Electron.
,
5 ,
962 -
981
-
24)
-
6. Rippel, W.E.: ‘Integrated motor drive and recharge system’. , 24 March 1992.
-
25)
-
21. Lechat Sanjuan, S.: ‘Voltage oriented control of three-phase boost PWM converters’. , Chalmers University of Technology, 2010.
-
26)
-
15. Haghbin, S., Guillen, I.: ‘Integrated motor drive and non-isolated battery charger based on the torque cancelation in the motor’. 2013 IEEE Tenth Int. Conf. Power Electronics and Drive Systems (PEDS), April 2013, pp. 824–829.
-
27)
-
14. Lacressonniere, F., Cassoret, B.: ‘Converter used as a battery charger and a motor speed controller in an industrial truck’. 2005 European Conf. Power Electronics and Applications, 2005.
-
28)
-
11. Lee, S.J., Sul, S.K.: ‘An integral battery charger for 4 wheel drive electric vehicle’. Industry Applications Society Annual Meeting, 1994., Conf. Record of the 1994 IEEE, October 1994, vol. 1, pp. 448–452.
-
29)
-
16. Estima, J., Marques Cardoso, A.: ‘Efficiency analysis of drive train topologies applied to electric/hybrid vehicles’, IEEE Trans. Veh. Technol. , 2012, 61, (3), pp. 1021–1031 (doi: 10.1109/TVT.2012.2186993).
-
30)
-
7. De Sousa, L., Silvestre, B., Bouchez, B.: ‘A combined multiphase electric drive and fast battery charger for electric vehicles’. IEEE Vehicle Power and Propulsion Conf. (VPPC) Proc. 2010, France, October 2010.
-
31)
-
2. Haghbin, S., Lundmark, S., Alakula, M., Carlson, O.: ‘Grid-connected integrated battery chargers in vehicle applications: review and new solution’, IEEE Trans. Ind. Electron., 2013, 60, (2), pp. 459–473 (doi: 10.1109/TIE.2012.2187414).
http://iet.metastore.ingenta.com/content/journals/10.1049/joe.2014.0126
Related content
content/journals/10.1049/joe.2014.0126
pub_keyword,iet_inspecKeyword,pub_concept
6
6