© The Institution of Engineering and Technology
In this study, a single switch isolated step-up converter is presented, which is derived from the traditional flyback converter and charge pump concept. The proposed converter possesses an output inductor, so the output current is non-pulsating. Moreover, there are several advantages of the proposed converter over the traditional flyback converter, such as higher voltage conversion ratio with only additional four passive elements, and smaller voltage and current ripples, except the same switch voltage stress. In this study, some experimental results are provided to verify the effectiveness of the proposed converter.
References
-
-
1)
-
16. Hwu, K.I., Tu, W.C.: ‘Voltage-boosting converters with hybrid energy pumping’, IEEE Trans. Power Electron., 2012, 5, (2), pp. 185–195.
-
2)
-
5. Deng, Y., Rong, Q., Zhao, S., Shi, J., He, X. ‘Single switch high step-up converters with built-in transformer voltage multiplier cell’, IEEE Trans. Power Electron., 2012, 27, (8), pp. 3557–3567 (doi: 10.1109/TPEL.2012.2183620).
-
3)
-
1. Erickson, R.W., Maksimovic, D.: ‘Fundamentals of power electronics’ (Kluwer Academic Publishers, Norwell, 2001, 2nd edn.).
-
4)
-
2. Lin, B.R., Hsieh, F.Y., Chen, J.J.: ‘Analysis and implementation of a bidirectional converter with high converter ratio’. IEEE Int. Conf. Industrial Technology (ICIT'08), 2008, pp. 1–6.
-
5)
-
R.J. Wai ,
R.Y. Duan
.
High step-up converter with coupled-inductor.
IEEE Trans. Power Electron.
,
5 ,
1025 -
1035
-
6)
-
10. Luo, F.L.: ‘Analysis of super-lift Luo-converters with capacitor voltage drop’. IEEE Conf. Industrial Electronics and Applications (ICIEA’ 08), 2008, pp. 417–422.
-
7)
-
11. Hwu, K.I., Yau, Y.T., Chen, Y.H.: ‘A novel voltage-boosting converter with passive voltage clamping’. IEEE Int. Conf. Sustainable Energy Technologies (ICSET'08), 2008, pp. 351–354.
-
8)
-
19. Bersani, A.: ‘AN1207 switch mode power supply (SMPS) topologies (Part II)’, , Microchip Technology Corporation, June 2012.
-
9)
-
B. Axelrod ,
Y. Berkovich ,
A. Ioinovici
.
Switched-capacitor/switched-inductor structures for getting transformerless hybrid DC–DC PWM converters.
IEEE Trans. Circuits Syst. I
,
2 ,
687 -
696
-
10)
-
R.J. Wai ,
R.Y. Duan
.
High-efficiency power conversion for low power fuel cell generation system.
IEEE Trans. Power Electron.
,
4 ,
847 -
856
-
11)
-
14. Hwu, K.I., Huang, K.W., Tu, W.C.: ‘Step-up converter combining KY and buck-boost converters’, IET Electron. Lett., 2011, 47, (12), pp. 722–724 (doi: 10.1049/el.2011.0392).
-
12)
-
20. Pressman, A.I.: ‘Switching power supply design’ (McGraw-Hill, New York, 1998, 2nd edn.).
-
13)
-
K.I. Hwu ,
Y.T. Yau
.
KY converter and its derivatives.
IEEE Trans. Power Electron.
,
1 ,
128 -
136
-
14)
-
12. Li, W., Li, W., He, X., Xu, D., Wu, B.: ‘General derivation law of nonisolated high-step-up interleaved converters with built-in transformers’, IEEE Trans. Ind. Electron., 2012, 59, (3), pp. 1650–1661 (doi: 10.1109/TIE.2011.2163375).
-
15)
-
14. Hwu, K.I., Yau, Y.T.: ‘Inductor-coupled KY boost converter’, IET Electron. Lett., 2010, 46, (24), pp. 1624–1626 (doi: 10.1049/el.2010.2400).
-
16)
-
C.T. Pan ,
C.M. Lai
.
A high-efficiency high step-up converter with low switch voltage stress for fuel-cell system applications.
IEEE Trans. Ind. Electron.
,
6 ,
1998 -
2006
-
17)
-
K.I. Hwu ,
Y.T. Yau
.
Two types of KY buck–boost converter.
IEEE Trans. Ind. Electron.
,
8 ,
2970 -
2980
-
18)
-
12. Hwu, K.I., Yau, Y.T.: ‘High step-up converter based on charge pump and boost converter’, IEEE Trans. Power Electron., 2012, 27, (5), pp. 2484–2494 (doi: 10.1109/TPEL.2011.2175010).
-
19)
-
18. Pavlovsky, M., de Hann, S.W.H., Ferreira, J.A.: ‘Reaching high power density in multikilowatt dc-dc converters with galvanic isolation’, IEEE Trans. Power Electron., 2009, 24, (3), pp. 603–612 (doi: 10.1109/TPEL.2008.2008650).
-
20)
-
13. Hwu, K.I., Yau, Y.T.: ‘A KY boost converter’, IEEE Trans. Power Electron., 2010, 25, (11), pp. 2699–2703 (doi: 10.1109/TPEL.2010.2051235).
http://iet.metastore.ingenta.com/content/journals/10.1049/iet-pel.2013.0825
Related content
content/journals/10.1049/iet-pel.2013.0825
pub_keyword,iet_inspecKeyword,pub_concept
6
6