Reduced sensor configuration of brushless DC motor drive using a power factor correction-based modified-zeta converter

Vashist Bist; Bhim Singh

Reduced sensor configuration of brushless DC motor drive using a power factor correction-based modified-zeta converter

View Fulltext

Author(s): Vashist Bist ¹ and Bhim Singh ¹
- Affiliations: 1: Department of Electrical Engineering, Indian Institute of Technology, New Delhi 110016, India
Source: Volume 7, Issue 9, September 2014, p. 2322 – 2335
DOI: 10.1049/iet-pel.2013.0177 , Print ISSN 1755-4535, Online ISSN 1755-4543

Received 12/03/2013, Accepted 22/05/2014, Revised 03/05/2014, Published 12/08/2014

This study deals with the design and development of a power factor (PF) correction-based modified-zeta converter fed brushless DC (BLDC) motor drive. A single-phase supply followed by a diode bridge rectifier and a modified-zeta converter operating in discontinuous inductor current mode (DICM) is used to feed a voltage source inverter (VSI) driving a BLDC motor. The modified-zeta converter operating in DICM acts as an inherent PF pre-regulator. A single-voltage sensor is used for the DC-link voltage control, which is used to control the speed of the BLDC motor. This facilitates the operation of VSI in fundamental frequency switching for reducing the switching losses in VSI. The proposed BLDC motor drive is designed and its performance is simulated in MATLAB/Simulink environment for achieving an improved power quality at AC mains for wide range of speed control. The obtained power quality indices are under the recommended limits of international power quality standard IEC 61000-3-2. Finally, the performance of the proposed drive is validated with test results obtained on a developed prototype of the proposed BLDC motor drive.

References

1. 1)
  - 21. Gopalarathnam, T., Toliyat, H.A.: ‘A new topology for unipolar brushless DC motor drive with high power factor’, IEEE Trans. Power Electron., 2003, 18, (6), pp. 1397–1404 (doi: 10.1109/TPEL.2003.818873).
2. 2)
  - 19. Cheng, L.: ‘DSP-based variable speed motor drive with power factor correction and current harmonics compensation’. 35th Intersociety Energy Conversion Eng. Conf. and Exhibit (IECEC), 2000, vol. 2, pp. 1394–1399.
3. 3)
  - 11. Sathyan, A., Milivojevic, M., Lee, Y.-J., Krishnamurthy, M., Emadi, A.: ‘An FPGA-based novel digital PWM control scheme for BLDC motor drives’, IEEE Trans. Ind. Electron., 2009, 56, (8), pp. 3040–3049 (doi: 10.1109/TIE.2009.2022067).
4. 4)
  - 28. Mohan, N., Undeland, T.M., Robbins, W.P.: ‘Power electronics: converters, applications and design’ (John Wiley and Sons Inc, USA, 2003).
5. 5)
  - 31. Texas Instruments, SPRS174R- TMS320F28xx Digital Signal Processors- Data Manual, May 2010.
6. 6)
  - 13. Limits for Harmonic Current Emissions (Equipment input current ≤ 16 A per phase), International Standard IEC 61000-3-2, 2000.
7. 7)
  - 2. Kenjo, T., Nagamori, S.: ‘Permanent magnet brushless DC motors’ (Clarendon Press, Oxford, 1985).
8. 8)
  - P. Pillay , R. Krishnan . Modeling of permanent magnet motor drives. IEEE Trans. Ind. Electron. , 4 , 537 - 541
9. 9)
  - B. Singh , B.N. Singh , A. Chandra , K. Al-Haddad , A. Pandey , D.P. Kothari . A review of single-phase improved power quality AC-DC converters. IEEE Trans. Ind. Electron. , 5 , 962 - 981
10. 10)
  - 5. Kim, J.H., Rhyu, S.H., Jung, I.S., Seo, J.M.: ‘An investigation on development of motor and gearheads for small mechanism’. Int. Conf. on Mechatronics and Automation, 2009 (ICMA 2009), 9–12 August 2009, pp. 1049–1053.
11. 11)
  - 26. Singh, S., Singh, B.: ‘Voltage controlled PFC Zeta converter based PMBLDCM drive for an air-conditioner’. 2010 Int. Conf. on Industrial and Information Systems (ICIIS), 29 July 2010–1 August 2010, pp. 550–555.
12. 12)
  - 7. Huang, X., Goodman, A., Gerada, C., Fang, Y., Lu, Q.: ‘A single sided matrix converter drive for a brushless DC motor in aerospace applications’, IEEE Trans. Ind. Electron., 2012, 59, (9), pp. 3542–3552 (doi: 10.1109/TIE.2011.2171171).
13. 13)
  - 8. Pillay, P., Krishnan, R.: ‘Application characteristics of permanent magnet synchronous and brushless DC motors for servo drives’, IEEE Trans. Ind. Appl., 1991, 27, (5), pp. 986–996 (doi: 10.1109/28.90357).
14. 14)
  - D.S.L. Simonetti , J. Sebastian , J. Uceda . The discontinuous conduction mode SEPIC and Cuk power factor preregulators: analysis and design. IEEE Trans. Ind. Electron. , 630 - 637
15. 15)
  - 23. Martins, D.C.: ‘Zeta converter operating in continuous conduction mode using the unity power factor technique’. Proc. IEE PEVSD'96, 1996, pp. 7–11.
16. 16)
  - 33. Alaeinovin, P., Jatskevich, J.: ‘Filtering of Hall-sensor signals for improved operation of brushless DC motors’, IEEE Trans. Energy Convers., 2012, 27, (2), pp. 547–549 (doi: 10.1109/TEC.2011.2180171).
17. 17)
  - 1. Xia, C.L.: ‘Permanent magnet brushless DC motor drives and controls’ (Wiley Press, Beijing, 2012).
18. 18)
  - 18. Madani, S.M., Lei, H., Toliyat, H.A.: ‘A low-cost four-switch BLDC motor drive with active power factor correction’. 28th Annual IEEE Conf. of Ind. Electron. Society (IECON),5–8 November 2002, vol. 1, pp. 579–584.
19. 19)
  - 17. Singh, B., Singh, S., Chandra, A., Al-Haddad, K.: ‘Comprehensive study of single-phase AC-DC power factor corrected converters with high-frequency isolation’, IEEE Trans. Ind. Inf., 2011, 7, (4), pp. 540–556 (doi: 10.1109/TII.2011.2166798).
20. 20)
  - 10. Toliyat, H.A., Campbell, S.: ‘DSP-based electromechanical motion control’ (CRC Press, New York, 2004).
21. 21)
  - 12. Rodriguez, F., Emadi, A.: ‘A novel digital control technique for brushless DC motor drives’, IEEE Trans. Ind. Electron., 2007, 54, (5), pp. 2365–2373 (doi: 10.1109/TIE.2007.900312).
22. 22)
  - 22. Singh, S., Singh, B.: ‘A voltage-controlled PFC Cuk converter based PMBLDCM drive for air-conditioners’, IEEE Trans. Ind. Appl., 2012, 48, (2), pp. 832–838 (doi: 10.1109/TIA.2011.2182329).
23. 23)
  - 4. Chen, Y., Chiu, C., Jhang, Y., Tang, Z., Liang, R.: ‘A driver for the single-phase brushless DC fan motor with hybrid winding structure’, IEEE Trans. Ind. Electron., 2012, 60, (10), pp. 4369–4375 (doi: 10.1109/TIE.2012.2209619).
24. 24)
  - 25. Singh, B., Chaturvedi, G.D.: ‘Analysis, design, modeling, simulation and development of single-switch AC-DC converters for power factor and efficiency improvement’, J. Power Electron., 2008, 8, (1), pp. 51–59.
25. 25)
  - 24. Niculescu, E., Niculescu, M.C., Purcaru, D.M.: ‘Modelling the PWM Zeta converter in discontinuous conduction mode’. 14th IEEE Mediterranean Electrotechnical Conf. (MELECON 2008), 5–7 May 2008, pp. 651–657.
26. 26)
  - 16. Vijayarajeswaran, R.: ‘DSP implementation of a power factor correction strategy for BLDC motor drive’. Int. J. Comput. Sci. Issues, 2012, 9, (1), no. 3, pp. 215–220.
27. 27)
  - 3. Sokira, T.J., Jaffe, W.: ‘Brushless DC motors: electronic commutation and control’ (Tab Books, USA, 1989).
28. 28)
  - 32. Fairchild Semiconductors, High Speed Transistor Optocouplers-6N136/6N137, August 2008.
29. 29)
  - V. Vlatkovic , D. Borojevic , F.C. Lee . Input filter design for power factor correction circuits. IEEE Trans. Power Electron. , 1 , 199 - 205
30. 30)
  - 27. Williams, B.: ‘Generation and analysis of canonical switching cell DC-to-DC converters’, IEEE Trans. Ind. Electron., 2014, 61, (1), pp. 329–346 (doi: 10.1109/TIE.2013.2240633).
31. 31)
  - 1. Singh, B., Singh, S.: ‘Single-phase power factor controller topologies for permanent magnet brushless DC motor drives’, IET Power Electron., 2010, 3, (2), pp. 147–175 (doi: 10.1049/iet-pel.2008.0313).
32. 32)
  - 17. George, G.J., Rakesh, R., Arun, N.: ‘PMBLDC motor drive with power factor correction controller’. Int. Conf. on Computing, Electronics and Electrical Technologies (ICCEET), 21–22 March 2012, pp. 63–68.
33. 33)
  - 6. Milivojevic, N., Krishnamurthy, M., Gurkaynak, Y., Sathyan, A., Lee, Y.-J., Emadi, A.: ‘Stability analysis of FPGA-based control of brushless DC motors and generators using digital PWM technique’, IEEE Trans. Ind. Electron., 2012, 59, (1), pp. 343–351 (doi: 10.1109/TIE.2011.2146220).

Login

Not registered yet?

Share

Tools

Login to add to favourites

Key

Reduced sensor configuration of brushless DC motor drive using a power factor correction-based modified-zeta converter

References

Related content