References

• 1. 1)
     • 1. Kjaer, S.B., Pedersen, J.K., Blaabjerg, F.: ‘A review of single-phase grid-connected inverters for photovoltaic modules’, IEEE Trans. Ind. Appl., 2005, 41, (5), pp. 1292–1306 (doi: 10.1109/TIA.2005.853371).
  2. 2)
     • 15. Yris, J.C., Calleja, H., Hernández, L., Olmos, J.: ‘Design and analysis of a grid connected inverter without isolation for an AC module’. IEEE Annual Applied Power Electronics Conf. and Exposition, 2012, pp. 2095–2099.
  3. 3)
     • 20. Axelrod, B., Berkovich, Y., Ioinovici, A.: ‘Switched-capacitor/switched-inductor structures for getting transformerless hybrid DC–DC PWM converters’, IEEE Trans. Circuits Syst. I, Regu. Pap., 2008, 55, pp. 687–696 (doi: 10.1109/TCSI.2008.916403).
  4. 4)
     • 7. Meneses, D., Blaabjerg, F., García, O., Cobos, J.A.: ‘Review and comparison of step-up transformerless topologies for photovoltaic AC-module application’, IEEE Trans. Power Electron., 2013, 28, pp. 2649–2663 (doi: 10.1109/TPEL.2012.2227820).
  5. 5)
     • 8. Vighetti, S., Ferrieux, J.-P., Lembeye, Y.: ‘Optimization and design of a cascaded DC/DC converter devoted to grid-connected photovoltaic systems’, IEEE Trans. Power Electron., 2012, 27, pp. 2018–2027 (doi: 10.1109/TPEL.2011.2167159).
  6. 6)
     • 26. http//www.solarcellsales.com/techinfo/docs/bp-485.pdf.
  7. 7)
     • 2. Lee, K.Y., Lai, Y.S.: ‘Novel circuit design for two-stage AC/DC converter to meet standby power regulations’, IET Power Electron., 2009, 2, pp. 625–634 (doi: 10.1049/iet-pel.2008.0190).
  8. 8)
     • 13. Zhao, Z., Xu, M., Chen, Q., Lai, J., Cho, Y.: ‘Derivation, analysis, and implementation of a boost–buck converter-based high-efficiency PV inverter’, IEEE Trans. Power Electron., 2012, 27, pp. 1304–1313 (doi: 10.1109/TPEL.2011.2163805).
  9. 9)
     • 9. Abdel-Rahim, O., Orabi, M., Ahmed, M.: ‘High gain single-stage inverter for photovoltaic AC modules’. IEEE Annual Applied Power Electronics Conf. and Exposition, 2011, pp. 1961–1967.
  10. 10)
      • 23. Erickson, R.W., Maksimovic, D.: ‘Fundamental of power electronics’ (Kluwer Academic Publishers, New York, 2004), pp. 187–204.
  11. 11)
      • 3. Abdel-Rahim, O., Orabi, M., Ahmed, M.: ‘Development of high-gain high-efficiency grid-connected inverter for PV module’. IEEE Symp. on Int. Power Electronics for Distributed Generation Systems, 2010, pp. 368–373.
  12. 12)
      • 27. Piegari, L., Rizzo, R.: ‘Adaptive perturb and observe algorithm for photovoltaic maximum power point tracking’, IET Renew. Power Gener., 2001, 4, (4), pp. 317–328 (doi: 10.1049/iet-rpg.2009.0006).
  13. 13)
      • 25. Huber, L., Zhang, J., Jovanović, M.M., Lee, F.C.: ‘Generalized topologies of single-stage input-current-shaping circuits’, IEEE Trans. Power Electron., 2001, 16, (4), pp. 508–513 (doi: 10.1109/63.931064).
  14. 14)
      • 6. Li, Q., Wolfs, P.: ‘A review of single phase photovoltaic module integrated converter topologies with three different DC link configurations’, IEEE Trans. Power Electron., 2008, 23, (3), pp. 1320–1332 (doi: 10.1109/TPEL.2008.920883).
  15. 15)
      • 21. Sayed, K., Abdel-Salam, M., Ahmed, A., Ahmed, M.: ‘New high voltage gain dual-boost DC–DC converter for photovoltaic power systems’, Electr. Power Compon. Syst., 2012, 40, pp. 711–728 (doi: 10.1080/15325008.2012.658596).
  16. 16)
      • 18. Kasa, N., Iida, T.: ‘Flyback type inverter for small scale photovoltaic power system’. IEEE Annual Conf. Industrial Electronics Society, (IECON, 2002), 2002, pp. 1089–1094.
  17. 17)
      • 5. Xiong, X., Ouyang, J.: ‘Modeling and transient behavior analysis of an inverter-based microgrid’, Electr. Power Compon. Syst., 2012, 40, pp. 112–130 (doi: 10.1080/15325008.2011.621926).
  18. 18)
      • 10. Barreto, L.H.S.C., Praça, P.P., Oliveira, D.S., Bascope, R.P.T.: ‘Single-stages topologies integrating battery charging, high voltage step-up and photovoltaic energy extraction capabilities’, IET Electron. Lett., 2011, 47, (1), pp. 49–50 (doi: 10.1049/el.2010.2944).
  19. 19)
      • 12. Karatepe, E., Syafaruddin Hiyama, T.: ‘Simple and high-efficiency photovoltaic system under non-uniform operating conditions’, IET Renew. Power Gener., 2010, 4, (4), pp. 354–368 (doi: 10.1049/iet-rpg.2009.0150).
  20. 20)
      • 14. Junior, L.G., de Brito, M.A.G., Sampaio, L.P., Canesin, C.A.: ‘Single stage converters for low power stand-alone and grid-connected PV systems’. IEEE Int. Symp. Industrial Electronics (ISIE), 2011, pp. 1112–1117.
  21. 21)
      • 4. Shen, J.-M., Jou, H.-L., Wu, J.-C.: ‘Novel transformerless grid-connected power converter with negative grounding for photovoltaic generation system’, IEEE Trans. Power Electron., 2012, 27, pp. 1818–1829 (doi: 10.1109/TPEL.2011.2170435).
  22. 22)
      • 24. Alagele, M.M., Abdalla, M.M., Zerek, A.: ‘Design and simulation of single stage single switch input current shaping circuit for AC/DC converter based on PWM technique’. Proc. Seventh IEEE Int. Multi-Conf. Systems, Signals and Devices, 2010.
  23. 23)
      • 19. Jain, S., Agarwal, V.: ‘Single-stage grid connected inverter topology for solar pv systems with maximum power point tracking’, IEEE Trans. Power Electron., 2007, 22, pp. 1928–1940 (doi: 10.1109/TPEL.2007.904202).
  24. 24)
      • 16. Patel, H., Agarwal, V.: ‘A single-stage single-phase transformer-less doubly grounded grid-connected PV interface’, IEEE Trans. Energy Convers., 2009, 24, (1), pp. 93–101 (doi: 10.1109/TEC.2008.2006551).
  25. 25)
      • 17. Zhang, Y., Woldegiorgis, A.T., Chang, L.: ‘Design and test of a novel buck-boost inverter with three switching devices’. IEEE Annual Applied Power Electronics Conf. and Exposition, APEC'2012, 2012, pp. 1973–1978.
  26. 26)
      • 11. Wang, Y.-J., Hsu, P.-C.: ‘Analytical modeling of partial shading and different orientation of photovoltaic modules’, IET Renew. Power Gener., 2010, 4, (3), pp. 272–282 (doi: 10.1049/iet-rpg.2009.0157).
  27. 27)
      • 22. Rosas-Caro, J.C., Ramirez, J.M., Peng, F.Z., Valderrabano, A.: ‘A DC–DC multilevel boost converter’, IET Proc. Power Electron., 2010, 3, pp. 129–137 (doi: 10.1049/iet-pel.2008.0253).