Nowadays, in several European Railway networks, the old DC supply systems are severely limited by line-voltage drops. In some sectors, it is not possible to increase traffic or to operate locomotives at their nominal ratings. To increase the capacity of a DC supply system, without additional substations, the authors propose a new three-wire supply system which restores the overhead line voltage with multilevel DC choppers operating as voltage boosters. Circuits using a third wire with a negative or a positive polarity are considered and compared. Case studies are presented for the French and Italian rail networks. Finally, experimental results performed on a test platform of the French railways, are presented in the case of a double 1.5 kV supply system.

References

1. 1)
  - 12. Wilkinson, R.H., Meynard, T., Mouton, H.: ‘Stability analysis of multicell converters’. IEEE AFRICON Conf., Botswana, September 2004.
2. 2)
  - 14. Hayashiya, H., Watanabe, Y., Fukasawa, Y., et al: ‘Cost impacts of high efficiency power supply technologies in railway power supply – traction and station’. Power Electronics and Motion Control Conf. (EPE/PEMC), Serbia, September 2012.
3. 3)
  - 13. Fabre, J., Ladoux, P., Piton, M.: ‘Characterization of SiC MOSFET dual modules for future use in railway traction chains’. PCIM 2012, Int. Conf. on Power Conversion and Intelligent Motion, Germany, May 2012.
4. 4)
  - 11. Wilkinson, R.H., Meynard, T., Mouton, H.: ‘Voltage unbalance in the multicell converter topology’. IEEE AFRICON Conf., South Africa, October 2002.
5. 5)
  - 7. Ladoux, P., Postiglione, G.: ‘Design of a line voltage booster in a new supply system for 1.5 kV catenaries’. PCIM 2007, Int. Conf. on Power Conversion and Intelligent Motion, Germany, May 2007.
6. 6)
  - 5. Fumi, A., Buffarini, G., Martini, G.: ‘Dimensionamento degli Impianti a 3 kV’, Tecnica Professionale dell΄ Ingegneria Ferrovaria, March 2006, no. 3.
7. 7)
  - T.A. Maynard , M. Fadel , N. Aouda . Modelling of multilevel converter. IEEE Trans. Ind. Electron. , 356 - 364
8. 8)
  - 6. Meynard, T., Foch, H.: ‘Multilevel choppers for high voltage applications’, Eur. Power Electron. J., 1992, 2, pp. 45–50.
9. 9)
  - 15. Gomez-Exposito, A., Mauricio, J.M., Maza-Ortega, J.M.: ‘VSC-Based MVDC railway electrification system’, IEEE Trans. Power Deliv., 2014, 2, (1), pp. 422–431.
10. 10)
  - 1. EN 50163 Standard: ‘Railway applications. Supply voltages of traction systems’, 2004.
11. 11)
  - 10. Cougo, B., Gateau, G., Meynard, T., Ladoux, P.: ‘Modulation strategies applied to series and parallel multilevel inverters’. PCIM 2011, Int. Conf. on Power Conversion and Intelligent Motion, Germany, May 2011.
12. 12)
  - 3. Alvarez, F., Ladoux, P., Caron, H., Josse, G., Perret, J.P.: ‘Une nouvelle structure d'alimentation des caténaires 1500 V: le système 2 × 1500 V’, Rev. Gén. Chemins Fer, 2006, 151, pp. 21–31.
13. 13)
  - 4. Aeberhardt, M., Courtois, C., Ladoux, P.: ‘Railway traction power supply from the state of the art to future trends’. IEEE Int. Symp. on Power Electronics, Electrical Drives, Automation and Motion, Italy, June 2010.
14. 14)
  - 8. Hamma, F., Meynard, T., Tourkhani, F., Viarouge, P.: ‘Characteristics and design of multilevel chopper’. IEEE Power Electronics Specialist Conf., USA, June 1995.
15. 15)
  - 7. Dolara, A., Gualdoni, M., Leva, S.: ‘Impact of high-voltage primary supply lines in the 2 × 25 kV–50 Hz railway system on the equivalent impedance at pantograph terminals’, IEEE Trans. Power Deliv., 2012, 27, (1), pp. 164–175 (doi: 10.1109/TPWRD.2011.2167635).

New three-wire supply systems for DC electric railways

References

Related content