© The Institution of Engineering and Technology
Novel high power density integrated electro-hydraulic machine for electrical hybrid working vehicles is presented. The machine is dedicated to be used as a mechanical power source for hydraulic actuators with possibility of electrical energy recuperation. Advantages of using such a machine in mobile environments are discussed. The efficiency of the device is studied and compared with the traditional valve controlled systems.
References
-
-
1)
-
7. Åman, R., Handroos, H., Ponomarev, P., Pyrhönen, J.: ‘Electro-hydraulic hybrid actuator system using integrated power unit’. Eighth Int. Fluid Power Conf., , Germany, 2012.
-
2)
-
2. Sgro, S., Inderelst, M., Murrenhoff, H.: ‘Energy efficient mobile working machines’. Seventh Int. Fluid Power Conf. Aachen, , Germany, 2010.
-
3)
-
3. Williamson, C., Ivantysynova, M.: ‘Power optimization for multi-actuator pump-controlled systems’. Seventh Int. Fluid Power Conf. Aachen, , Germany, 2010.
-
4)
-
11. Gieras, J., Wing, M.: ‘Permanent magnet motor technology: design and applications’ (Marcel Dekker Incorporated, 2002).
-
5)
-
8. Åman, R., Handroos, H., Wilenius, J., Ponomarev, P.: ‘Test rig for integrated hydraulic-electric power transmission with real-time simulated loads’. Seventh FPNI PhD Symp. on Fluid Power, Reggio Emilia, Italy, 2012.
-
6)
-
4. Sciberras, E.A., Norman, R.A.: ‘Multi-objective design of a hybrid propulsion system for marine vessels’, IET Electr. Syst. Transp., 2012, 2, (3), pp. 148–157 (doi: 10.1049/iet-est.2011.0011).
-
7)
-
3. Williamson, C., Ivantysynova, M.: ‘Power optimization for multi-actuator pump-controlled systems’. Seventh Int. Fluid Power Conf. Aachen, RWTH Aachen University, Germany, 2010.
-
8)
-
7. Åman, R., Handroos, H., Ponomarev, P., Pyrhönen, J.: ‘Electro-hydraulic hybrid actuator system using integrated power unit’. Eighth Int. Fluid Power Conf., Dresden University of Technology, Germany, 2012.
-
9)
-
1. Refaie, A.M.E.: ‘Fractional-slot concentrated-windings synchronous permanent magnet machines: opportunities and challenges’, IEEE Trans. Ind. Electron., 2010, 57, (1), pp. 107–121 (doi: 10.1109/TIE.2009.2030211).
-
10)
-
11)
-
17. Brahmer, B.: ‘CLDP – hybrid drive using servo pump in closed loop’. 8th Int. Fluid Power Conf., , Germany.
-
12)
-
1. Callaghan, L., Lynch, S.: ‘Analysis of Electric Drive Technologies for Transit Applications; Battery-Electric, Hybrid-Electric and Fuel Cells’. . Northeast Advanced Vehicle Consortium, Boston, USA, 2005.
-
13)
-
12. Ponomarev, P., Polikarpova, M., Pyrhonen, J.: ‘Conjugated fluid-solid heat transfer modeling of a directly-oil-cooled PMSM using CFD’. 2012 Int. Symp. on Power Electronics, Electrical Drives, Automation and Motion (SPEEDAM), 20–22 June 2012, pp. 141–145.
-
14)
-
14. Bosch Rexroth AG. 2011. .
-
15)
-
13. Ponomarev, P., Lindh, P., Pyrhonen, J.: ‘Effect of slot-and-pole combination on the leakage inductance and the performance of tooth-coil permanent-magnet synchronous machines’, IEEE Trans. Ind. Electron., 2013, 60, (10), pp. 4310–4317 (doi: 10.1109/TIE.2012.2216246).
-
16)
-
2. Sgro, S., Inderelst, M., Murrenhoff, H.: ‘Energy efficient mobile working machines’. Seventh Int. Fluid Power Conf. Aachen, RWTH Aachen University, Germany, 2010.
-
17)
-
18)
-
18. Minav, T., Laurila, L., Pyrhönen, J., Vtorov, V.: ‘Direct pump control effects on the energy efficiency in an electro-hydraulic lifting system’, Int. Rev. Autom. Control, 2011, 4, (2), pp. 8, .
-
19)
-
10. Ponomarev, P., Polikarpova, M., Heinikainen, O., Pyrhonen, J.: ‘Design of integrated electro-hydraulic power unit for hybrid mobile working machines’. Proc. of the 2011–14th European Conf. on Power Electronics and Applications (EPE 2011), Auguest 30 2011–September 1 2011, pp. 1–10.
-
20)
-
6. Hubei Fotma Machinery Co.Ltd. .
-
21)
-
15. Liebherr-Aero-Technik GmbH: .
http://iet.metastore.ingenta.com/content/journals/10.1049/iet-est.2013.0009
Related content
content/journals/10.1049/iet-est.2013.0009
pub_keyword,iet_inspecKeyword,pub_concept
6
6