© The Institution of Engineering and Technology
The paper presents a modelling approach for symmetrical minor hysteresis loops in the rolling (RD) and transverse (TD) directions for grain-oriented (GO) laminations. A recently proposed modified Jiles–Atherton model which considers crystallographic orientation of GO laminations is extended to predict RD and TD minor loops. A power scaling rule for updation of model parameters is applied for the purpose. Two model parameters (k and a) are updated with the maximum flux density in RD. It gives reasonably accurate prediction in this direction. On the other hand, in TD, three model parameters (k, a and c) are modified to predict minor loops accurately. The proposed model is validated using measured curves in both directions. A close agreement is observed between computed and experimental ones. The model is useful for design and analysis of core joints and corners under rotating and distorted flux patterns.
References
-
-
1)
-
7. Yoon, H., Koh, C.S.: ‘Vector magnetic property of electrical steel sheet and its influence on distributions of magnetic field and iron loss for electrical machines’, COMPEL: Int. J. Comput. Math. Electr. Electron. Eng., 2014, 33, pp. 14–27.
-
2)
-
K.H. Carpenter
.
A differential equation approach to minor loops in the Jiles-Atherton hysteresis model.
IEEE Trans. Magn.
,
4404 -
4406
-
3)
-
4. Takahashi, S., Kobayashi, S., Shishido, T.: ‘A scaling power-low relation in magnetic minor hysteresis loops in Fe and Ni metals’, J. Phys. Condens. Matter, 2008, 20, pp. 035217-1–035217-6.
-
4)
-
23. Baghel, A.P.S., Kulkarni, S.V.: ‘Parameter identification of the Jiles-Atherton hysteresis model using a hybrid technique’, IET-Electr. Power Appl., 2012, 6, pp. 689–695 (doi: 10.1049/iet-epa.2011.0249).
-
5)
-
16. Chwastek, K., Szczyglowski, J., Wilczynski, W.: ‘Modeling dynamic hysteresis loops in steel sheets’, COMPEL Int. J. Comput. Math. Electr. Electron. Eng., 2009, 28, pp. 603–612 (doi: 10.1108/03321640910940873).
-
6)
-
27. Ivanyi, A.: ‘Hysteresis models in electromagnetic computation’ (Akadémiai Kiadó, Budapest, 1997).
-
7)
-
D.C. Jiles ,
D.L. Atherton
.
Theory of ferromagnetic hysteresis.
J. Magn. Magn. Mater.
,
48 -
60
-
8)
-
22. Baghel, A.P.S., Kulkarni, S.V.: ‘Hysteresis modeling of the grain-oriented laminations with inclusion of crystalline and textured structure in a modified Jiles-Atherton model’, J. Appl. Phys.2013, 113, pp. 043908-1–043908-5 (doi: 10.1063/1.4788806).
-
9)
-
17. Hamimid, M., Mimoune, S.M., Feliachi, M.: ‘Minor hysteresis loop model based on exponential parameter scaling of the modified Jiles-Atherton model’, Physica B, 2012, 407, pp. 2438–2441 (doi: 10.1016/j.physb.2012.03.042).
-
10)
-
20. Takahashi, S., Kobayashi, S., Kamada, Y., Kikuchi, H., Zhang, L., Ara, K.: ‘Analysis of minor hysteresis loops and dislocations in Fe’, Physica B, 2006, 372, pp. 190–193 (doi: 10.1016/j.physb.2005.10.045).
-
11)
-
Z. Wlodarski
.
The Jiles-Atherton model with variable pinning parameter.
IEEE Trans. Magn.
,
1990 -
1992
-
12)
-
24. Fiorillo, F., Dupre, L.R., Appino, C., Rietto, A.M.: ‘Comprehensive model of magnetization curve, hysteresis loops, and losses in any direction in grain-oriented Fe-Si’, IEEE Trans. Magn., 2002, 38, pp. 1467–1476 (doi: 10.1109/20.999119).
-
13)
-
5. Benabou, A., Leite, J.V., Clenet, S., Simao, C., Sadowski, N.: ‘Minor loops modeling with a modified Jiles-Atherton model and comparison with the Preisach model’, J. Magn. Magn. Mater., 2008, 320, pp. 1034–1038 (doi: 10.1016/j.jmmm.2008.04.092).
-
14)
-
14. Leite, J.V., Benabou, A., Sadowski, N.: ‘Accurate minor loop calculation with a modified Jiles-Atherton hysteresis model’, COMPEL: Int. J. Comput. Math. Electr. Electron. Eng., 2009, 28, pp. 741–749 (doi: 10.1108/03321640910940990).
-
15)
-
28. Baghel, A.P.S., Shekhawat, S.K., Kulkarni, S.V., Samajdar, I.: ‘Modeling of dynamic hysteresis for grain-oriented laminations using a viscosity-based modified dynamic Jiles-Atherton model’, Physica B, 2014, 448, pp. 349–353 (doi: 10.1016/j.physb.2014.04.012).
-
16)
-
26. Ramesh, A., Jiles, D.C., Roderick, J.M.: ‘A model of anisotropic anhysteretic magnetization’, IEEE Trans. Magn., 1996, 32, pp. 4234–4236 (doi: 10.1109/20.539344).
-
17)
-
15. Chwastek, K.: ‘Modeling offset minor hysteresis loops with the modified Jiles-Atherton description’, J. Phys. D Appl. Phys., 2009, 42, pp. 165002–165007 (doi: 10.1088/0022-3727/42/16/165002).
-
18)
-
1. Bertotti, G.: ‘Hysteresis in magnetism’ (Academic, San Diego, CA, 1998).
-
19)
-
21. Takahashi, S., Kobayashi, S.: ‘Scaling power-law relations in asymmetrical minor hysteresis loops’, J. Appl. Phys.2010, 107, pp. 063903-1–063903-5.
-
20)
-
D.C. Jiles
.
A self consistent generalized model for the calculation of minor loops excursions in the theory of hysteresis.
IEEE Trans. Magn.
,
2602 -
2604
-
21)
-
3. Kefalas, T.D., Kladas, A.G.: ‘Harmonic impact on distribution transformer no load loss’, IEEE Trans. Ind. Electron., 2010, 57, pp. 193–200 (doi: 10.1109/TIE.2009.2030207).
-
22)
-
19. Miljavec, D., Zidaric, B.: ‘Introducing a domain flexing function in the Jiles-Atherton hysteresis model’, J. Magn. Magn. Mater., 2008, 320, pp. 763–768 (doi: 10.1016/j.jmmm.2007.08.016).
-
23)
-
2. Kulkarni, S.V., Khaparde, S.A.: ‘Transformer engineering: design, technology, and diagnostics’ (Taylor & Francis Group, CRC Press, 2012).
-
24)
-
18. Hamimid, M., Mimoune, S.M., Feliachi, M.: ‘Evaluation of minor hysteresis loops using Langevin transforms in modified inverse Jiles-Atherton model’, Physica B, 2013, 429, pp. 115–118 (doi: 10.1016/j.physb.2013.08.014).
-
25)
-
25. Shin, S., Schaefer, R., DeCooman, B.C.: ‘Anisotropic magnetic properties and domain structure in Fe-3%Si (110) steel sheet’, J. Appl. Phys.2011, 109, pp. 07A307-1–07A307-3.
-
26)
-
9. Naghizadeh, R.A., Vahidi, B., Hosseinian, S.H.: ‘Modeling of inrush current in transformers using inverse Jiles-Atherton hysteresis model with Neuro-shuffled frog-leaping algorithm approach’, IET-Electr. Power Appl., 2012, 6, pp. 727–735 (doi: 10.1049/iet-epa.2012.0085).
-
27)
-
10. Toms, H.L., Colclaser, R.G., Krefta, M.P.: ‘Two-dimensional finite element magnetic modeling for scalar hysteresis effects’, IEEE Trans. Magn., 2001, 37, pp. 982–988 (doi: 10.1109/20.917181).
-
28)
-
6. Chwastek, K.: ‘Anisotropic properties of non-oriented steel sheets’, IET-Electr. Power Appl., 2013, 7, pp. 575–579 (doi: 10.1049/iet-epa.2013.0087).
http://iet.metastore.ingenta.com/content/journals/10.1049/iet-epa.2014.0268
Related content
content/journals/10.1049/iet-epa.2014.0268
pub_keyword,iet_inspecKeyword,pub_concept
6
6