© The Institution of Engineering and Technology
This paper proposes an on-board integrated battery charger for an electric-propulsion system. The system includes a rectifying diode bridge, an inverter, a permanent magnet motor, a digital signal processor, a battery set and three relays. By suitably controlling the three relays and the power switches of the inverter, the proposed system can be operated as either an electric-propulsion system or a battery charger. The integrated battery charger can be used to charge a 48 V battery set or a 192 V battery set from a single-phase 110 V rms grid. The battery charger can be operated in a boost-converter charging mode or in buck-converter charging mode with input power factor higher than 0.9 when operating with 48 V battery or 192 V battery, which can meet the IEC 1000-3-2 standard. Only a diode bridge, an inductance-capacitance (LC) filter, and three additional relays are required in addition to the components for propulsion. The windings of the motor and the power switches of the inverter are shared for both the electric-propulsion system and the battery charger. A digital signal processor, TMS-320-F-2808, is used to execute all of the control algorithms. Experimental results validate the theoretical analysis and separately show the correctness and feasibility of the proposed method.
References
-
-
1)
-
12. Sousa, L. De., Bouchez, B.: ‘Combined electric device for powering and charging’, .
-
2)
-
2. Khaligh, A., Dusmez, S.: ‘Comprehensive topological analysis of conductive and inductive charging solutions for PHEV’, IEEE Trans. Veh. Technol., 2012, 61, (8), pp. 3475–3489 (doi: 10.1109/TVT.2012.2213104).
-
3)
-
A. Emadi ,
Y.J. Lee ,
K. Rajashekara
.
Power electronics and motor drives in electric, hybrid electric, and plug-in hybrid electric vehicles.
IEEE Trans. Ind. Electron.
,
6 ,
2237 -
2245
-
4)
-
20. Hunter, P.M., Anbuky, A.H.: ‘VRLA battery virtual reference electrode: battery float charge analysis’, IEEE Trans. Energy Convers., 2008, 23, (3), pp. 879–886 (doi: 10.1109/TEC.2008.926041).
-
5)
-
8. Bruyere, A., Sousa, L.De, Bouchez, B., Sandulescu, P., Kestelyn, X., Semail, E.: ‘A multiphase traction/fast-battery-charger drive for electric or plug-in hybrid vehicles’. Proc. IEEE VPPC, Lille, France, 2010.
-
6)
-
1. Wirasingha, S.G., Emadi, A.: ‘Classification and review of control strategies for plug-in hybrid electric vehicles’, IEEE Trans. Veh. Technol., 2011, 60, (1), pp. 111–122 (doi: 10.1109/TVT.2010.2090178).
-
7)
-
L. Solero
.
Nonconventional on-board charger for electric vehicle propulsion batteries.
IEEE Trans. Veh. Technol.
,
1 ,
144 -
149
-
8)
-
7. Sousa, L.De, Silvestre, B., Bouchez, B.: ‘A combined multiphase electric drive and fast battery charger for electric vehicles’. Proc. IEEE VPPC, Lille, France, 2010.
-
9)
-
15. Yilmaz, M., Krein, P.: ‘Review of battery charger topologies, charging power levels and infrastructure for plug-in electric and hybrid vehicles’, IEEE Trans. Power Electron., 2012, 28, (5), pp. 2151–2169 (doi: 10.1109/TPEL.2012.2212917).
-
10)
-
1. Rajashekara, K.: ‘Present status and future trends in electric vehicle propulsion technologies’, IEEE J. Emerging Sel. Top. Power Electron., 2013, 1, (1), pp. 3–10 (doi: 10.1109/JESTPE.2013.2259614).
-
11)
-
12. Ying-Chun, C., Yu-Lung, K., Hung-Shiang, C., Shun-Yi, C.: ‘Battery float charge technique using parallel-loaded resonant converter for discontinuous conduction operation’, IEEE Trans. Ind. Appl., 2012, 48, (3), pp. 1070–1078 (doi: 10.1109/TIA.2012.2190961).
-
12)
-
G. Pellegrino ,
E. Armando ,
P. Guglielmi
.
An integral battery charger with power factor correction for electric scooter.
IEEE Trans. Power Electron.
,
3 ,
751 -
759
-
13)
-
2. Zhang, M., Yang, Y., Mi, C.C.: ‘Analytical approach for the power management of blended-mode plug-in hybrid electric vehicles’, IEEE Trans. Veh. Technol., 2012, 61, (4), pp. 1554–1566 (doi: 10.1109/TVT.2012.2187318).
-
14)
-
15. Lee, Y.J., Khaligh, A., Enadi, A.: ‘Advanced integrated bidirectional AC/DC and DC/DC converter for plug-in hybrid electric vehicles’, IEEE Trans. Veh. Technol., 2009, 58, (8), pp. 3970–3980 (doi: 10.1109/TVT.2009.2028070).
-
15)
-
9. Lacroix, S., Laboure, E., Hilairet, M.: ‘An integrated fast battery charger for electric vehicle’. Proc. IEEE VPPC, Lille, France, 2010.
-
16)
-
18. Khan, M.A., Husain, I., Sozer, Y.: ‘Integrated electric motor drive and power electronics for bidirectional power flow between the electric vehicle and DC or AC grid’, IEEE Trans. Power Electron., 2013, 28, (12), pp. 5774–5783 (doi: 10.1109/TPEL.2013.2258471).
-
17)
-
H.C. Chang ,
C.M. Liaw
.
Development of a compact switched-reluctance motor drive for EV propulsion with voltage boosting and PFC charging capabilities.
IEEE Trans. Veh. Technol.
,
7 ,
3198 -
3215
-
18)
-
A. Emadi ,
S. Williamson ,
A. Khaligh
.
Power electronics intensive solutions for advanced electric, hybrid electric, and fuel cell vehicular power systems.
IEEE Trans. Power Electron.
,
3 ,
567 -
577
-
19)
-
18. Yilmaz, M., Krein, P.T.: ‘Review of the impact of vehicle-to-grid technologies on distribution systems and utility interfaces’, IEEE Power Electronics, 2013, 28, (12), pp. 5673–5689 (doi: 10.1109/TPEL.2012.2227500).
-
20)
-
2. Haghbin, S., Lundmark, S., Alakula, M., Carlson, O.: ‘Grid-connected integrated battery chargers in vehicle applications: review and new solution’, IEEE Trans. Ind. Electron., 2013, 60, (2), pp. 459–473 (doi: 10.1109/TIE.2012.2187414).
-
21)
-
13. Haghbin, S., Khan, K., Zhao, S., Alakula, M., Lundmark, S., Carlson, O.: ‘An integrated 20-kw motor drive and isolated battery charger for plug-in vehicles’, IEEE Trans. Power Electron., 2013, 28, (8), pp. 4013–4029 (doi: 10.1109/TPEL.2012.2230274).
http://iet.metastore.ingenta.com/content/journals/10.1049/iet-epa.2014.0168
Related content
content/journals/10.1049/iet-epa.2014.0168
pub_keyword,iet_inspecKeyword,pub_concept
6
6