© The Institution of Engineering and Technology
This study investigates the implementation of predictive current control for an interior permanent magnet synchronous motor (IPMSM) drive system. By measuring the current deviation of each switching interval, the optimal switching state of the inverter can be determined. As a result, the proposed method is insensitive to the variations of the motor parameters. In addition, a satisfactory tracking ability of the current-loop control can be achieved. An adaptive inverse controller, which includes adaptive modelling and adaptive control, is used as a speed-loop control to enhance the performance of the adjustable closed-loop speed control system, including fast transient responses, good load disturbance responses and satisfactory tracking responses. A digital signal processor (DSP), TMS-320LF-2407, is used to execute the predictive current control and the adaptive inverse controller. As a result, the hardware is very simple. Experimental results show that the proposed method can effectively improve the performance of an IPMSM drive.
References
-
-
1)
-
16. Consoli, A., Scelba, G., Scarcella, G., Cacciato, M.: ‘An effective energy-saving scalar control for industrial IPMSM drives’, IEEE Trans. Ind. Electron., 2013, 60, (9), pp. 3658–3669 (doi: 10.1109/TIE.2012.2207651).
-
2)
-
M.N. Uddin ,
M.M.I. Chy
.
Online parameter-estimation-based speed control of PM AC motor drive in flux-weakening region.
IEEE Trans. Ind. Appl.
,
5 ,
1486 -
1494
-
3)
-
28. Maciejowski, J.M.: ‘Predictive control with constraints’ (Prentice-Hall, New Jersey, 2002).
-
4)
-
J.L. Shi ,
T.H. Liu ,
Y.C. Chang
.
Position control of an interior permanent-magnet synchronous motor without using a shaft position sensor.
IEEE Trans. Ind. Electron.
,
4 ,
1989 -
2000
-
5)
-
10. Ha, J.I.: ‘Current prediction in vector-controlled PWM inverters using single DC-link current sensor’, IEEE Trans. Ind. Electron., 2010, 57, (2), pp. 716–726 (doi: 10.1109/TIE.2009.2028361).
-
6)
-
8. Kim, H., Degner, M.W., Guerrero, J.M., Briz, F., Lorenz, R.D.: ‘Discrete-time current regulator design for AC machine drives’, IEEE Trans. Ind. Appl., 2010, 46, (4), pp. 1425–1435 (doi: 10.1109/TIA.2010.2049628).
-
7)
-
18. Guo, L., Parsa, L.: ‘Model reference adaptive control of five-phase IPM motors based on neural network’, IEEE Trans. Ind. Electron., 2012, 59, (3), pp. 1500–1508 (doi: 10.1109/TIE.2011.2163371).
-
8)
-
C.B. Butt ,
M.A. Hoque ,
M.A. Rahman
.
Simplified fuzzy-logic-based MTPA speed control of IPMSM drive.
IEEE Trans. Ind. Appl.
,
6 ,
1529 -
1535
-
9)
-
29. Camacho, E.F., Bordons, C.: ‘Model predictive control’ (Springer-Verlag, London, 2003).
-
10)
-
24. Caponio, A., Cascella, G.L., Neri, F., Salvatore, N., Sumner, M.: ‘A fast adaptive memetic algorithm for online and offline control design of PMSM drives’, IEEE Trans. Syst. Man Cybern. B, Cybern., 2007, 37, (1), pp. 28–41 (doi: 10.1109/TSMCB.2006.883271).
-
11)
-
21. Mohamed, Y.A.R.I.: ‘A newly designed instantaneous-torque control of direct-drive PMSM servo actuator with improved torque estimation and control characteristics’, IEEE Trans. Ind. Electron., 2007, 54, (5), pp. 2864–2873 (doi: 10.1109/TIE.2007.901356).
-
12)
-
H.Z. Jin ,
J.M. Lee
.
An RMRAC current regulator for permanent magnet synchronous motor based on statistical model interpretation.
IEEE Trans. Ind. Electron.
,
1 ,
169 -
177
-
13)
-
25. Qin, X., Wang, Y., Wei, Z., Zheng, J.: ‘An online calibrating method for middle value of current measurement circuit in permanent magnet synchronous motor drives’. IEEE PACIIA, 2009, pp. 66–70.
-
14)
-
19. Butt, C.B., Rahman, M.A.: ‘Untrained artificial neuron-based speed control of interior permanent-magnet motor drives over extended operating speed range’, IEEE Trans. Ind. Appl., 2013, 49, (3), pp. 1146–1153 (doi: 10.1109/TIA.2013.2253533).
-
15)
-
17. Khan, M.A.S.K., Rahman, M.A.: ‘A novel neuro-wavelet-based self-tuned wavelet controller for IPM motor drives’, IEEE Trans. Ind. Appl., 2010, 46, (3), pp. 1194–1203 (doi: 10.1109/TIA.2010.2045213).
-
16)
-
20. Foo, G.H.B., Rahman, M.F.: ‘Direct torque control of an IPM-synchronous motor drive at very low speed using a sliding-mode stator flux observer’, IEEE Trans. Power Electron., 2010, 25, (4), pp. 933–942 (doi: 10.1109/TPEL.2009.2036354).
-
17)
-
1. Inoue, Y., Morimoto, S., Sanada, M.: ‘Examination and linearization of torque control system for direct torque controlled IPMSM’, IEEE Trans. Ind. Appl., 2010, 46, (1), pp. 159–166 (doi: 10.1109/TIA.2009.2036540).
-
18)
-
11. Uddin, M.N.: ‘An adaptive-filter-based torque-ripple minimization of a fuzzy-logic controller for speed control of IPM motor drives’, IEEE Trans. Ind. Appl., 2011, 47, (1), pp. 350–358 (doi: 10.1109/TIA.2010.2090316).
-
19)
-
29. Hejny, R.W., Lorenz, R.D.: ‘Evaluating the practical low-speed limits for back-EMF tracking-based sensorless speed control using drive stiffness as a key metric’, IEEE Trans. Ind. Appl., 2011, 47, (3), pp. 1337–1343 (doi: 10.1109/TIA.2011.2126013).
-
20)
-
12. Rebeiro, R.S., Uddin, M.N.: ‘Performance analysis of an FLC-based online adoption of both hysteresis and PI controllers for IPMSM drive’, IEEE Trans. Ind. Appl., 2012, 48, (1), pp. 12–19 (doi: 10.1109/TIA.2011.2175876).
-
21)
-
22. Lascu, C., Boldea, I., Blaabjerg, F.: ‘Super-twisting sliding mode control of torque and flux in permanent magnet synchronous machine drives’. IEEE IECON, 2013, pp. 3171–3176.
-
22)
-
12. Boldea, I., Paicu, M.C., Andreescu, G.-D., Blaabjerg, F.: ‘‘Active flux’’ dtfc-svm sensorless control of ipmsm’, IEEE Trans. Energy Convers., 2009, 24, (2), pp. 314–322 (doi: 10.1109/TEC.2009.2016137).
-
23)
-
26. Zeng, M., Zhao, Q., Fang, C.: ‘Designing and tuning current loop on AC servo system based on PMSM’. IEEE MACE, 2011, pp. 1209–1212.
-
24)
-
30. Widrow, B., Walach, E.: ‘Adaptive inverse control’ (Prentice-Hall, New Jersey, 1996).
-
25)
-
7. Bae, B.H., Sul, S.K.: ‘A compensation method for time delay of full-digital synchronous frame current regulator of PWM AC drives’, IEEE Trans. Ind. Appl., 2003, 39, (3), pp. 802–810 (doi: 10.1109/TIA.2003.810660).
-
26)
-
13. Chy, M.M.I., Uddin, M.N.: ‘Development and implementation of a new adaptive intelligent speed controller for IPMSM drive’, IEEE Trans. Ind. Appl., 2009, 45, (3), pp. 1106–1115 (doi: 10.1109/TIA.2009.2018918).
-
27)
-
14. Morawiec, M.: ‘The adaptive backstepping control of permanent magnet synchronous motor supplied by current source inverter’, IEEE Trans. Ind. Inf., 2013, 9, (2), pp. 1047–1055 (doi: 10.1109/TII.2012.2223478).
-
28)
-
2. Jung, S.Y., Hong, J., Nam, K.: ‘Current minimizing torque control of the IPMSM using Ferrari's method’, IEEE Trans. Power Electron., 2013, 28, (12), pp. 5603–5617 (doi: 10.1109/TPEL.2013.2245920).
-
29)
-
Y.A.-R.I. Mohamed ,
E.F. Ei-Saadany
.
A current scheme with an adaptive internal model for torque ripple minimization and robust current regulation in PMSM drive system.
IEEE Trans. Energy Convers.
,
1 ,
92 -
100
-
30)
-
M. Kadjoudj ,
M.E.H. Benbouzid ,
C. Ghennai ,
D. Diallo
.
A robust hybrid current control for permanent-magnet synchronous motor drive.
IEEE Trans. Energy Convers.
,
109 -
115
-
31)
-
28. Preindl, M., Bolognani, S.: ‘Model predictive direct speed control with finite control set of PMSM drive systems’, IEEE Trans. Power Electron., 2013, 28, (2), pp. 1007–1015 (doi: 10.1109/TPEL.2012.2204277).
http://iet.metastore.ingenta.com/content/journals/10.1049/iet-epa.2014.0035
Related content
content/journals/10.1049/iet-epa.2014.0035
pub_keyword,iet_inspecKeyword,pub_concept
6
6