© The Institution of Engineering and Technology
Achieving wireless connectivity in ever smaller, lower power portable devices with increasing number of features and better radio-frequency (RF) performance is becoming difficult to fulfill through existing RF front-end technology. RF micro-electro-mechanical systems (MEMS) switch technology, which has significantly better RF characteristics than conventional technology and has near-zero power consumption, is one of the emerging solutions for next generation RF front-ends. However, to achieve satisfactory RF MEMS device performance, it is often necessary to have an actuating circuitry to generate high direct current (DC) voltages for device actuation with low power consumption. In this study, the authors present an RF MEMS switch controller based on a switched-capacitor (SC) DC–DC converter in a 0.35 μm CMOS technology. In this design, novel design techniques for a higher output voltage and lower power consumption in a smaller die area are proposed. The authors demonstrate the design of the high-voltage (HV) SC DC–DC converter by using low-voltage transistors and address reliability issues in the design. Through the proposed design techniques, the SC DC–DC converter achieves more than 25% higher boosted voltage compared to converters that use HV transistors. The proposed design provides 40% power reduction through the charge recycling circuit. Moreover, the SC DC–DC converter achieves 45% smaller than the area of the conventional converter.
References
-
-
1)
-
8. Wong, Y.C., Zhou, W., El-Rayis, A.O., Haridas, N., Erdogan, A.T., Arslan, T.: ‘Practical design strategy for two-phase step up DC-DC fibonacci switched-capacitor converter’. 20th European Conf. Circuit Theory and Design (ECCTD), 2011, pp. 817–820.
-
2)
-
7. Makowski, M.S.: ‘On performance limits of switched-capacitor multi-phase charge pump circuits.’. Int. Conf. Signals and Electronic Systems (ICSES), 2008, pp. 309–312.
-
3)
-
4. Starzyk, J.A., Ying-Wei, J., Fengjing, Q.: ‘A DC-DC charge pump design based on voltage doublers’, IEEE Trans. Circuits Syst. I: Fundam. Theory Appl., 2001, 48, pp. 350–359 (doi: 10.1109/81.915390).
-
4)
-
23. Aaltonen, L., Saukoski, M., Halonen, K.: ‘On-chip digitally tunable high voltage generator for electrostatic control of micromechanical devices’. IEEE Custom Integrated Circuits Conf. (CICC), 2006, pp. 583–586.
-
5)
-
11. Cha, J., Ahn, M., Cho, C., Lee, C.-H., Haksun, K., Laskar, J.: ‘Analysis and design techniques of CMOS charge-pump-based radio-frequency antenna-switch controllers’, IEEE Trans. Circuits Syst. I: Regul. Pap., 2009, 56, pp. 1053–1062 (doi: 10.1109/TCSI.2009.2016129).
-
6)
-
7)
-
13. Arslan, T., Walton, A.J., Haridas, N.: ‘Micro electromechanical capacitive switch’. 2009.
-
8)
-
20. David, M., Johns, A.: ‘Analog integrated circuit design’ (John Wiley & Sons, Inc., 1997).
-
9)
-
5. Pelliconi, R., Iezzi, D., Baroni, A., Pasotti, M., Rolandi, P.L.: ‘Power efficient charge pump in deep submicron standard CMOS technology’, IEEE J. Solid-State Circuits, 2003, 38, pp. 1068–1071 (doi: 10.1109/JSSC.2003.811991).
-
10)
-
1. Rebeiz, G.M.: ‘RF MEMS switches: status of the technology’. 12th Int. Conf. Solid-State Sensors, Actuators and Microsystems, 2003, vol. 2, pp. 1726–1729.
-
11)
-
18. Palumbo, G., Pappalardo, D., Gaibotti, M.: ‘Charge-pump circuits: power-consumption optimization’, IEEE Trans. Circuits Syst. I: Fundam. Theory Appl., 2002, 49, pp. 1535–1542 (doi: 10.1109/TCSI.2002.804544).
-
12)
-
14. Wong, Y.C., Arslan, T., Erdogan, A.T.: ‘Reconfigurable wideband RF impedance transformer integrated with an antenna for multi-band wireless devices’. Loughborough Antennas & Propagation Conf. (LAPC), 2012, pp. 1–5.
-
13)
-
6. Richard, J.F., Savaria, Y.: ‘High voltage charge pump using standard CMOS technology’. Second Annual IEEE Northeast Workshop on Circuits and Systems (NEWCAS), 2004, pp. 317–320.
-
14)
-
19. Mensi, R.L., Colalongo, L., Rolandi, P.L., Kovacs-Vajna, Z.M.: ‘A 1.2-to-8 V charge-pump with improved power efficiency for non-volatile memories’. IEEE Int. Solid-State Circuits Conf. (ISSCC), 2007, pp. 522–619.
-
15)
-
22. Allasasmeh, Y., Gregori, S.: ‘Charge reusing in switched-capacitor voltage multipliers with reduced dynamic losses’. 53rd IEEE Int. Midwest Symp. Circuits and Systems (MWSCAS), 2010, pp. 1169–1172.
-
16)
-
21. Hong, D.S., El-Gamal, M.N.: ‘Low operating voltage and short settling time CMOS charge pump for MEMS applications’. Proc. Int. Symp. Circuits and Systems (ISCAS), 2003, vol. 5, pp. V-281–V-284.
-
17)
-
17. Van Breussegem, T.M., Wens, M., Geukens, E., Geys, D., Steyaert, M.S.J.: ‘Area-driven optimisation of switched-capacitor DC/DC converters’, Electron. Lett., 2008, 44, pp. 1488–1490 (doi: 10.1049/el:20081687).
-
18)
-
10. Ker, M.-D., Chen, S.-L., Tsai, C.-S.: ‘Design of charge pump circuit with consideration of gate-oxide reliability in low-voltage CMOS processes’, IEEE J. Solid-State Circuits, 2006, 41, pp. 1100–1107 (doi: 10.1109/JSSC.2006.872704).
-
19)
-
9. Tanzawa, T.: ‘On two-phase switched-capacitor multipliers with minimum circuit area’, IEEE Trans. Circuits Syst. I, 2010, 57, pp. 2602–2608 (doi: 10.1109/TCSI.2010.2046958).
-
20)
-
12. Mohammad, M.G., Ahmad, M.J., Al-Bakheet, M.B.: ‘Switched positive/negative charge pump design using standard CMOS transistors’, IET Circuits, Dev. Syst., 2010, 4, pp. 57–66 (doi: 10.1049/iet-cds.2008.0349).
-
21)
-
3. Wu, J.-T., Chang, K.-L.: ‘MOS charge pumps for low-voltage operation’, IEEE J. Solid-State Circuits, 1998, 33, pp. 592–597 (doi: 10.1109/4.735702).
-
22)
-
2. Dickson, J.F.: ‘On-chip high-voltage generation in MNOS integrated circuits using an improved voltage multiplier technique’, IEEE J. Solid-State Circuits, 1976, 11, pp. 374–378 (doi: 10.1109/JSSC.1976.1050739).
-
23)
-
16. Seeman, M.D.: ‘A design methodology for switched-capacitor DC–DC converters’. EECS Department, University of California, Berkeley, , 2009.
http://iet.metastore.ingenta.com/content/journals/10.1049/iet-cds.2012.0327
Related content
content/journals/10.1049/iet-cds.2012.0327
pub_keyword,iet_inspecKeyword,pub_concept
6
6